LAVAMAT 74800Washing MachineUser information
10Before the first wash1. Open the detergent drawer.2. Pour approx. 1 litre of water through the detergent drawer into the washing machine. This close
11Running a wash cycleOpening the door/loading washing1. Open the door: pull the handle on the door.When the appliance is switched on, the DOOR and ST
12• Water softener should be used from water hardness range 2 (=medi-um). The amount of detergent used can then always be that as for hardness range 1
13Switching on the appliance/selecting a programmeSet the programme and tempera-ture using the programme selector. 3 The appliance is switched on by s
14Selecting additional programmesIf required, press additional pro-gramme button(s). The correspond-ing indicator will illuminate. 3 If “Err” flashes
15Setting the delay timer3 Using the DELAY TIMER button you can delay the start of a programme by 30 minutes (30') to a maximum of 23 hours (23h)
16Interrupting a programme/adding washingInterrupting a programme• A programme can at any time be interrupted by pressing the START/PAUSE button and r
17Child safety deviceIf the child safety device has been activated, the door can no longer be shut.Activating the child safety device:Use a coin to tu
18Cleaning and careImportant: Do not use furniture cleaning products or aggressive clean-ing agents to clean the appliance. Wipe over the control pane
19What to do if...Remedying small faults yourselfIf during use of the appliance one of the following error codes is shown in the multi-display:– E10 (
2Dear Customer,Please read this user information carefully and keep it to refer to later.Please pass the user information on to any future owner of th
20E10 appears.The END indicator is flashing once, and simultaneously an acoustic signal is sounding once.(Problems with the water inflow.)The tap is s
21Conditioner has not been rinsed in, compartment w for conditioner is filled with water.The softener insert in the compartment for conditioners has n
22If the wash result is not satisfactoryThe washing is grey and there are limescale deposits in the drum• Too little detergent was used.• An incorrect
23Carrying out an emergency drain1 Warning! Prior to carrying out an emergency drain, switch off the washing machine and remove the power plug from th
24Drain pumpThe drain pump is maintenance-free. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pum
25Disposal2Packaging materialThe packaging materials are environmentally friendly and can be recy-cled. The plastic components are identified by marki
26Technical data5This appliance conforms with the following EU Directives:– 73/23/EEC dated 19.02.1973 Low Voltage Directive– 89/336/EEC dated 03.05.1
27Installation and connection instructions1 Safety information concerning installation• This washing machine cannot be built-in.• Before using for the
28Installing the applianceTransporting the appliance1 Warning: The washing machine is very heavy. There is a risk of injury. Exercise care when liftin
293. Remove both plastic caps sideways. 3 Special spanner A and sealing caps B (2 units) and C (1 unit) come with the appliance.4. Use special spanner
3ContentsOperating Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5Safety . . . . . . . . . . . . . . . . . . .
30Where to installImportant! The washing machine must not be operated in a room where there is a danger of frost. There is a risk of frost damage or a
31Making the appliance levelThe four feet of the appliance are pre-adjusted. Large degrees of unevenness can be compensated for by individually ad-jus
32• The wire coloured blue must be connected to the terminal “N“ or coloured black.• The wire coloured brown must be connected to the terminal marked
33Connecting the appliance to the water supplyImportant: • This appliance must not be connected to the hot water supply.• When connecting the applianc
34Water inletA 1.35m long pressure hose is supplied with the appliance. If a longer inlet hose is required, only hoses from the manufacturer are to be
35Water DrainageThe appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece“ supplied. The
36Pumping heights of over 1 metreThe washing machine’s drain pump is able to pump water to a height of 1metre, calculated from the surface on which th
37Warranty conditionsGreat BritainStandard guarantee conditionsWe, AEG, undertake that if within 12 months of the date of the purchase this AEG applia
39Service and Spare PartsIf the event of your appliance requiring service, or if you wish to pur-chase spare parts, please contact Service Force by te
4Installation and connection instructions. . . . . . . . . . . . . . . . . 27Safety information concerning installation . . . . . . . . . . . . . . .
From the Electrolux Group. The world´s No.1 choice.The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning an
5Operating Instructions1 SafetyPrior to using the appliance for the first time• Follow the “Installation and connection instructions”.• If the applian
6General safety• Repairs to the washing machine may only be carried out by qualified/authorised service engineers. • Never use the appliance when the
7Description of the applianceControl panel Detergent drawerScrew feet(height adjustable)Plinth flap/Drain pumpRating plate(behind door)Control panelDE
8Programme overviewProgrammemax. load 1) (dry washing) 1) A 10 litre bucket contains approx. 2.5 kg dry washing (cotton)Additional programmes Spin spe
9Application/FeaturesCaresymbols1) 1) The figures in the care symbols indicate the maximum temperatures.Energy-saving programme which washes at 60 °C
Comments to this Manuals