AEG L9FEA966C User Manual download pdf (Page 47)

45°

20°

16.9 Emergency drain

If the appliance cannot drain the water,

carry out the same procedure, described

in 'Cleaning the drain pump' paragraph.

If necessary, clean the pump.

When you drain the water with the

emergency drain procedure, you must

activate the drain system again:

1. Put 2 litres of water in the main wash

compartment of the detergent

dispenser.

2. Start the programme to drain the

water.

16.10 Frost precautions

If the appliance is installed in an area

where the temperature can reach the

values around 0° C or drop below,

remove the remaining water from the

inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in

a container and let the water flow out

of the hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty,

install the inlet hose again.

WARNING!

Make sure that the

temperature is higher than 0

°C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

17. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

17.1 Introduction

WARNING!

Deactivate the appliance

before carrying out any

check.

The appliance does not start or it stops

during operation.

First try to find a solution to the problem

(refer to the "Possible failures" table). If

the problem persists, contact the

Authorised Service Centre.

In case of major problems, the buzzer

operates, an alarm message pops and

the Start/Pause button may flash

continuously, e.g.:

• Check that the water inlet tap is

open - The appliance does not fill

with water properly.

• Check that the drain filter is not

clogged - The appliance does not

drain the water.

• Check that the door is properly

closed - The appliance door is open

or not closed correctly. Please check

the door!

If the appliance is

overloaded, remove

some items from the

drum and/or keep the

door pressed while

pressing the Start/Pause

button until the indicator

stops flashing (see

the picture below).

ENGLISH 47

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 59 60

Comments to this Manuals

No comments