AEG L87695WD User Manual download pdf (Page 31)

13.8 Emergency drain

Because of a malfunction, the appliance

cannot drain the water.

If this occurs, do steps (1) through (9) of

'Cleaning the drain filter'. If necessary,

clean the pump.

When you drain the water with the

emergency drain procedure, you must

activate again the drain system:

1. When you drain the water with the

emergency drain procedure, you

must activate again the drain system:

Put 2 litres of water in the main wash

compartment of the detergent

dispenser.

2. Start the programme to drain the

water

13.9 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0° C, remove the remaining water from

the inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in

a container and let the water flow out

of the hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty,

install the inlet hose again.

WARNING!

Make sure that the

temperature is more than 0

°C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

14. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

14.1 Introduction

The start of the appliance does not occur

or it stops during operation.

First try to find a solution to the problem

(refer to the table). If not, contact the

Authorised Service Centre.

With some problems, the acoustic

signals operate and the display shows

an alarm code:

•

- The appliance does not fill with

water properly.

•

- The appliance does not drain

the water.

•

- The appliance door is open or

not closed correctly. Please check the

door!

•

- The mains supply is unstable.

Wait until the mains supply is stable.

•

- No communication between

electronic elements of the appliance.

Switch off and switch on again.

•

- The anti-flood device is on.

Disconnect the appliance and close

the water tap. Contact the Authorised

Service Centre.

WARNING!

Deactivate the appliance

before you do the checks.

14.2 Possible failures

Problem Possible solution

The programme does

not start.

Make sure that the mains plug is connected to the mains sock-

et.

ENGLISH 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments