AEG L87480FL User Manual download pdf (Page 36)

Installation on a not hard floor

When you install the appliance on a not

hard floor (wooden planks floor), put a

rigid support plinth under the appli-

ance feet to prevent the noise and the

vibration.

Assemble the plinth with a waterproof

wood panel (min. 15 mm thick) and at-

tach it to the beams of the floor with

minimum 2 screws.

The plinth must extend of some cm

more than the edges of the appliance.

We recommend you to install the appli-

ance in one of the corners of the room,

where the floor is more stable.

THE INLET HOSE

35

O

35

O

35

O

45

O

45

O

45

O

• Connect the hose to the appliance.

Turn the inlet hose only left or right.

Loose the ring nut to set it in the cor-

rect position.

• Connect the water inlet hose to the

cold water tap with 3/4 thread.

CAUTION!

Make sure that there are no

leaks from the couplings.

Do not use an extension hose if

the inlet hose is too short. Con-

tact the service centre for the re-

placement of the inlet hose.

Water pressure

The appliance works correctly if the wa-

ter pressure is not less than 0.05 MPa

(0.5 bar).

If you can not connect the water inlet

hose to the cold water tap of the pri-

mary hydraulic system, connect it to

your domestic cold water storage sys-

tem.

Make sure not to have more than a dis-

tance of 5.02 m (16.5 ft) between the

appliance inlet hose and the bottom of

the water storage tank.

36

1 2 ... 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments