AEG L82470BI User Manual download pdf (Page 24)

Problem Possible solution

You cannot open the ap-

pliance door.

• Make sure that the washing programme is finished.

• Set the drain or the spin programme if there is water in the

drum.

The appliance makes an

unusual noise.

• Make sure the levelling of the appliance is correct. Refer to

'Installation'.

• Make sure that the packaging and/or the transit bolts are

removed. Refer to 'Installation'.

• Add more laundry in the drum. The load may be too small.

The washing results are

not satisfactory.

• Increase the detergent quantity or use a different deter-

gent.

• Use special products to remove the stubborn stains before

you wash the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

You cannot set an op-

tion.

• Make sure that you press only the wanted button(s).

After the check, activate the appliance.

The programme continues from the

point of interruption.

If the problem occurs again, contact the

Authorised Service Centre.

If the display shows other alarm codes.

Deactivate and activate the appliance. If

the problem continues, contact the

Service.

14. INSTALLATION

14.1 Unpacking

WARNING!

Remove all the packaging and the transit bolts before installing the

appliance.

Use the gloves. Remove the external film. If

necessary, use a cutter.

www.aeg.com24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

No comments

AEG L82470BI User Manual Page 24