AEG L7FC8432BI User Manual download pdf (Page 38)

12.8 Cleaning the inlet hose and the valve filter

1

2

3

45°

20°

12.9 Emergency drain

If the appliance cannot drain the water,

carry out the same procedure, described

in 'Cleaning the drain pump' paragraph.

If necessary, clean the pump.

When you drain the water with the

emergency drain procedure, you must

activate the drain system again:

1. Put 2 litres of water in the main wash

compartment of the detergent

dispenser.

2. Start the programme to drain the

water.

12.10 Frost precautions

If the appliance is installed in an area

where the temperature can reach values

around 0° C or drop below, remove the

remaining water from the inlet hose and

the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in

a container and let the water flow out

of the hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty,

install the inlet hose again.

WARNING!

Make sure that the

temperature is higher than 0

°C before you use the

appliance again.

The manufacturer is not

responsible for damages

caused by low temperatures.

13. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

www.aeg.com38

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Comments to this Manuals

No comments