L 76285 FLL 76485 FLEN User manual
Spin phase is off.'Rinse Hold' function ison.5.10 Temperature button 10Press button 10 to change the defaulttemperature.- - = cold water5.11
ProgrammeTemperatureType of loadmax. weight ofloadCycle description FunctionsCottons + Pre-wash95° - ColdWhite and colouredcotton with heavysoil.max.
ProgrammeTemperatureType of loadmax. weight ofloadCycle description FunctionsRinse Hand washingitems.RinsesLong spinSPIN REDUC-TIONRINSE HOLDEXTRA RIN
STEAM PROGRAMMESProgramme1)Type of load Max. load Steam RefreshThis cycle removes odoursfrom the laundry.Steam does not re-move animal odours.Cotton a
7. CONSUMPTION VALUESAt programme start the display shows the duration programme for the max-imum load capacity.During the washing phase the programme
8. BEFORE FIRST USE1.To activate the drain system, put 2 li-tre of water in the main wash com-partment of the detergent dispens-er.2.Put a small quant
The detergent compartment for the prewash phase and thesoak programme.Add the detergent for prewash and soak before the start of theprogramme.The dete
4.To use liquid detergent, turn theflap down.With the flap in the positionDOWN:– Do not use gelatinous or thickliquid detergents.– Do not put more liq
2.Press button 4 , the appliancestarts the countdown of the delaystart.When the countdown is completed,the programme starts automatically.Before you p
10. HINTS AND TIPS10.1 The laundry load• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that ar
CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY
Water hardness tableLevel TypeWater hardness°dH °T.H. mmol/l Clarke1 soft 0-7 0-15 0-1.5 0-92 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.
11.6 Detergent dispenserTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquidadditive compartment.4.
To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the
129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven
Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the dra
Problem Possible cause Possible solutionThe appliancedoes not drain thewater.The water drain hose isdamaged.Make sure that the water drainhose has no
Problem Possible cause Possible solution Leakages from the drainpump.Make sure that the drain pumpfilter is tight. The water drain hose isdamaged.Ma
13. INSTALLATION13.1 Fixing plate kit(4055171146)Available from your authorized dealer.If you install the appliance on a plinth,secure the appliance i
5.Open the door. Remove the poly-styrene piece from the door sealand all the items from the drum.6.Put one of the polystyrene packag-ing elements on t
10.Remove the three bolts. Use the keysupplied with the appliance.11.Pull out the plastic spacers.12.Put the plastic caps in the holes.You can find th
1. SAFETY INFORMATIONBefore the installation and use of the appliance, careful-ly read the supplied instructions. The manufacturer isnot responsible i
• The appliance must be level and sta-ble.CAUTION!Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the level.Make s
• Connect the water inlet hose to thecold water tap with 3/4 thread.CAUTION!Make sure that there are no leaksfrom the couplings.Do not use an extensio
• On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the water tap orthe wall.• To a
• Directly to a built-in drain pipe in theroom wall and tighten it with a clip.You can extend the drain hose tomaximum 400 cm. Contact theservice cent
34www.aeg.com
ENGLISH 35
www.aeg.com/shop132912420-A-122013
• If the supply cord is damaged, it must be replaced bythe manufacturer, its service agent or similarly quali-fied persons in order to avoid a hazard.
mains plug, use a 13 amp ASTA (BS1362) fuse.•This appliance complies with theE.E.C. Directives.Water connection• Make sure not to cause damage to thew
Level of protection against ingress of solid particlesand moisture ensured by the protective cover, ex-cept where the low voltage equipment has no pro
4.1 Accessories1 2341SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear sideof the cabinet after the removal ofthe transit
5.1 On Off button 1Press this button to activate or deacti-vate the appliance. A tune sounds whenthe appliance is activated.The AUTO Stand-by function
D • The programme timeWhen the programme starts, the time decreases with steps of 1 mi-nute.• The delay startWhen you press the delay start button, th
Comments to this Manuals