AEG ST 500 Service Manual download pdf (Page 20)

21 GB

Before start-up / Operation

WARNING!

Take care for the correct polarity.

Take care the terminals do not touch each other.

To disconnect, execute the process in reverse

order – ﬁrst of all remove the black terminal

clip

7

and then the red terminal clip

6

from

the battery.

The earth connection with butterﬂy nut

14

should be connected to an earth spike which

is ﬁxed into the ground at a minimum depth

of at least 1.2 m, or connect it directly with

the earth connection of the mains. If the

on-board power supply does not have an

earth connection, it is preferable to connect

the negative pole of the supply battery with

the earth spike. Use a yellow/green jacketed

cable with a cross section of > 0.75 mm².

WARNING!

You must earth the voltage

converter before you start to use it.

The maximum operation period of the converter

is deﬁned by the available battery capacity Rec-

ommended battery minimum capacity during

stationary use:

– 97115 (Model ST 500): 60 Ah, 97116 (Model

ST 800): 95 Ah, 97117 (Model ST 1200):

160 Ah

– 97120 (Model SW 600): 74 Ah, 97121 (Model

SW 1000): 120 Ah, 97122 (Model SW 1500):

190 Ah

Operation

Connect the remote control

Completely unwind the cable of the remote

control module

10

and place the plug of the

cable into the connection remote control

5

on the voltage converter.

Attach external devices

Place the plug of the external appliance into

the output socket

8

on the voltage con-

verter and / or connect the external USB

appliance to the USB output

4

.

Switch on the voltage inverter by pressing

the key ON/OFF/MODE

3

for approx. 3 sec-

onds. The voltage converter is ready for

operation when the green LED-display

2

lights up. Please read the chapter „error

tracing “if the red LED-display

1

lights up.

Now switch on the (external) devices con-

nected with the voltage converter.

Information: You can use all outputs at the

same time. The total nominal capacity for all

external appliances may not be exceeded as

mentioned under „Technical Data“.

The nominal capacity of external appliance

is shown on the identiﬁcation plate, which is

in a certain place on this external appliance.

External appliances like electric motors, drills,

electrical saws, refrigerators and music syste

ms,

normally require a larger nominal capacity

when starting than indicated on the identiﬁ-

cation plate. If the nominal capacity is indi-

cated in ampere only, multiply the value in

ampere by a factor of 230, in order to receive

the capacity in Watts.

For example: 0.4 A x 230 = 92 Watts

Output socket / Output 230 V

8

Use only external devices, which are either

equipped

with bonding contact pins or European fork wall

plugs.

USB output

4

Connect the external USB-device with the USB

output

4

and switch it on. The USB output of

this voltage converter supplies a direct current of

5 V for external USB devices (e.g. Lamps, fans,

radios).

The USB output is always switched on, if the volt

age

converter is connected to the 12 V-input socket.

WARNING!

The USB output on the voltage converter is not

intended for the data communication. Do not

attach a memory stick, MP3-Player or similar

external data memory devices. Do not connect

data communication cables to the USB exit!

97115_AEG_Spannungswandler_Content_EU.indd 21 26.08.11 13:03

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 62 63

Comments to this Manuals

No comments