SKS51000S0ENREFRIGERATOR USER MANUAL
There are some sounds during normal use (compressor, refrigerant circulation).Problem Possible cause SolutionThe appliance does not op-erate. The lamp
Problem Possible cause Solution Many products are stored atthe same time.Store less products at the sametime. There is no cold air circulationin the
INSTALLATIONPositioningWARNING!If you are discarding an old appliance that has a lock or catch on the door, you mustensure that it is made unusable to
4. With a key, loosen the lower pin.On the opposite side:1. Tighten the lower pin.2. Install the spacer.3. Install the door.4. Tighten the upper pin.V
2. Install the appliance in the niche.Push the appliance in the direction ofthe arrow (1) until the upper gap coverstops against the kitchen furniture
5. Remove the correct part from thehinge cover (E). Make sure to removethe part DX, in the case of right hinge,SX in opposite case.6. Attach the cover
8. Install the part (Ha) on the inner sideof the kitchen furniture door.9. Push the part (Hc) on the part (Ha).10. Open the appliance door and the kit
11. Remove the brackets and mark a dis-tance of 8 mm from the outer edge ofthe door where the nail must be fitted(K).12. Place the small square on the
product, please contact your local council, your household waste disposal service or theshop where you purchased the product.18
FOR PERFECT RESULTSThank you for choosing this AEG product. We havecreated it to give you impeccable performance for manyyears, with innovative techno
www.aeg-electrolux.com/shop 212710342-00-20052010
CONTENTS4 Safety information6 Operation7First use7Daily use7 Helpful hints and tips8 Care and Cleaning9 What to do if…11 Technical data12 Installation
SAFETY INFORMATIONIn the interest of your safety and to ensure the correct use, before installing and firstusing the appliance, read this user manual
• It is dangerous to alter the specifications or modify this product in any way. Any dam-age to the cord may cause a short-circuit, fire and/or electr
• Adequate air circulation should be around the appliance, lacking this leads to overheat-ing. To achieve sufficient ventilation follow the instructio
• the location of the appliance.If the ambient temperature is high or the appliance is fully loaded, and the appliance isset to the lowest temperature
ing frost or ice on the evaporator. If this happens, set the Temperature Regulator to-ward warmer settings to allow automatic defrosting and so a savi
Take care of not to damage the cooling system.Many proprietary kitchen surface cleaners contain chemicals that can attack/damage theplastics used in t
Comments to this Manuals