AEG EPB351020M User Manual download pdf (Page 30)

The cleaning reminder

goes out:

• after the end of the

pyrolysis.

• if you press and at

the same time while PYR

flashes in the display.

11.6 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

The door is heavy.

1. Open the door fully.

2. Fully lift up the clamping levers (A) on

the two door hinges.

A

A

3. Close the door until it is at an angle

of approximately 45°.

45°

4. Hold the door with one hand on each

side and pull it away from the oven at

an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

1

2

B

CAUTION!

Rough handling of the glass,

especially around the edges

of the front panel, can cause

the glass to break.

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

Make sure that you put the glass panels

(C, B and A) back in the correct

sequence. First, insert panel C, which has

a square printed on the left side and a

triangle on the right side. You will also

find those symbols embossed on the

door frame. The triangle symbol on the

glass must match the triangle on the

door frame, and the square symbol must

www.aeg.com

30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments