AEG DC7013021M User Manual download pdf (Page 24)

1. Pull the front of the shelf support

away from the side wall.

2. Pull the rear end of the shelf support

away from the side wall and remove

it.

1

2

Install the shelf supports in the opposite

sequence.

The retaining pins on the

telescopic runners must

point to the front.

12.4 Catalytic cleaning

CAUTION!

Do not clean the catalytic

surface with oven sprays,

abrasive cleaning agents,

soap or other cleaning

agents. This will damage the

catalytic surface.

Spots or discolouration of

the catalytic surface have no

effect on catalytic

properties.

WARNING!

Keep children away when

you clean the oven at a high

temperature. The oven

surface becomes very hot

and there is a risk of burns.

CAUTION!

Always turn the oven light on

while using the catalytic

cleaning (if applicable).

Before activating the

catalytic cleaning remove all

the accessories from the

oven.

The walls with a catalytic coating are self-

cleaning. They absorb fat which collects

on the walls while the appliance

operates.

To support the self-cleaning procedure,

heat the empty oven on a regular basis.

1. Clean the oven floor with warm water

and washing up liquid, then dry it.

2. Set the CATA function.

Oven will switch off after one hour.

3. When the appliance is cool, clean it

with a soft and moist sponge.

12.5 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully lift up the clamping levers (A) on

the two door hinges.

A

A

3. Close the door until it is at an angle

of approximately 45°.

www.aeg.com

24

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comments to this Manuals

No comments