AEG PROTECT A. 700 Operations Instructions download pdf (Page 39)

♦ To execute the manual check press the button

for

abo

ut five seconds until the UPS acoustic signal

fades out.

♦ Additionally the button has the function to deactivate

the acoustic alarm signal. Press the button

when

the acoustic alarm it audible for about 1 second. The

tone stops.

Any new error that is reported by a signal

activates the alarm signal again.

Note:

The acoustic signal can not be switched off in

the following situations:

Battery weak, overload, fan failure, fan error,

If the monitoring electronics detect an irregularity during the

procedure d

back onto th

same time, an acoustic fault signal and the corresponding

time cutout, overheat.

escribed above, the load is immediately switched

e mains and is thus supplied with voltage. At the

signals from LEDs in acc. with Chapter 6 "Signalling" are

output.

Faults detected and signalled during diagnosis

must be rectified; otherwise there is a risk o

load voltage loss if a mains failure occurs!

5.6 Interfaces

5.6.1 Data line p

(modem / telephone / fax / network)

to the “IN” line at the

nnected via data line

and communication

tection RJ11 and RJ45 ro

The incoming data lines are connected

rear of the UPS. The “OUT” line is co

with your terminal.

The data line protection supports networks with

transfer rates between 10 and 100 MBit/s.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 53 54

No comments

AEG PROTECT A. 700 Operations Instructions Page 39