AEG WSP 3010 Operations Instructions Page 29
- Page / 64
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
29
English
For the Fitter
A bridged must be inserted between ”N” and ”A2/Z2” for operation with ”single-wire control”**!
Power adaptation according to rated charging time
By moving or removing bridges at the terminals, the output can be adapted to the rated charging
time specified by the electricity supply company.
Unit rating plate
Observe the labelling on the rating plate and the circuit diagram!
After connecting electrically, the box corresponding to the connection rating and rated charging
time of the unit on the rating plate and the circuit diagram in these installation instructions should
be marked with a smear-proof ballpoint pen.
2.5.3 Unit Ready for Operation
Cleaning the unit (fig. 13 and 14)
The open unit must be cleaned after installation and insertion of the storage blocks.
The fans and the air guidance assembly must be removed for this.
• Unscrew and remove the air guidance assembly (16)
• Lift and remove the fan (18) after loosening (not removing) the screws at the front of the support
brackets (pay attention to cable laying!).
In some units, the discharge temperature control unit (19) including support plate must be uns-
crewed.
Make sure the wires are not damaged when setting down the removed parts.
• Clean the floor plate and fan (avoid damage to lamellas!). Then re-install the fans, possibly the
temperature limiter and the air guidance module (correct cable laying!).
Close the unit (fig. 15 and 16)
• Hang in the inside front wall with thermal insulation swung forward slightly at an angle at the
top edge and screw at the bottom edge with 2 screws;
• Hang in the right side wall at the bottom, tilt up, hang in at top and fix with screws (b1 and b2);
(reverse order see
2.5.1 – disassembly right side wall fig. 6);
• Hang in front wall at top, swing to the heater at the bottom and fix with 2 screws
(always use the two inside threaded holes) (fig. 15);
• Tighten the air inlet grille (5) with both the quarter-turn caps (fig. 16);
• Hang the top edge of the air inlet grille in the lock screws at the air guidance assembly and then
press the bottom over the catch springs (fig. 16).
Heating element model
Rated charging time
Connection variants (kW)
Model
WSP 2010
WSP 3010
WSP 4010
WSP 5010
WSP 6010
WSP 7010
8h
➀
2.0
3.0
4.0
5.0
6.0
7.0
8h (series)
9h
➁
1.83
2.75
3.66
4.58
5.5
6.42
10h
➂
1.67
2.5
3.33
4.16
5.0
5.83
6h (heating element fitting set)
6h
➁
2.47
3.76
5.04
5.96
7.42
8.24
5h
➀
2.7
4.1
5.5
6.5
8.1
9.0
7h
➂
2.25
3.42
4.58
5.42
6.75
7.5
91.6 % P
rated
83.3 % P
rated
100 % P
rated
(series wiring)
268301 - 34573 - 0738.indd 29 19.09.2007 15:39:48
- WSP 2010, WSP 3010 1
- WSP 4010, WSP 5010 1
- WSP 6010, WSP 7010 1
- Inhaltsverzeichnis 2
- Table of Contents 2
- Inhoudsoverzicht 2
- 1 Gebrauchsanweisung 6
- 1.3 Sicherheitshinweise 7
- 1.4 Pflege und Wartung 7
- Für den Benutzer 7
- 1.5 Wichtiger Hinweis 8
- Was tun wenn . . . ? 8
- 2 Montageanweisung 9
- Für den Installateur 10
- 2.4 Montageort 12
- 2.6 Erstinbetriebnahme 16
- 2.8 Übergabe 16
- Stromlaufplan WSP 2010 - 7010 17
- Kundendienst und Garantie 19
- 3.1 Umwelt und Recycling 20
- 1 Operating Instructions 21
- 1.3 Safety Instructions 22
- 1.4 Care and Maintenance 22
- For the User 22
- For the User and Fitter 23
- What to do when . . . ? 23
- 1.5 Important Note 23
- 2 Installation Instructions 24
- For the Fitter 25
- (series wiring) 26
- 2.4 Installation Site 27
- 2.6 First-time Operation 31
- 2.8 Transfer 31
- 3 Guarantee 34
- 1 Notice d’utilisation 35
- 1.3 Consignes de sécurité 36
- 1.4 Entretien et maintenance 36
- « CLIC » 37
- 2 Notice de montage 38
- Francais 39
- 2.2.1 Fonctionnement 39
- (câblage série) 40
- 2.4 Site de montage 41
- 43
- 43
- ** « Commande unifilaire » 44
- Modèle type 45
- Thermostat d’ambiance Intégré 46
- Chauffage auxiliaire 46
- 3 Garantie 48
- 1 Gebruiksaanwijzing 49
- Voor de gebruiker 50
- 1.3 Veiligheidsvoorschriften 50
- 1.4 Verzorging en onderhoud 50
- "CLIC" 51
- 2 Montagehandleiding 52
- Voor de installateur 53
- (standaard bedrading) 54
- 2.4 Montageplaats 55
- Voorbeeld 59
- 3 Garantie 62
- Notizen / Notice 63
- Adressen und Kontakte 64
Related products and manuals for Space heaters AEG WSP 3010
Space heaters AEG WSP 5010 User Manual
(56 pages)
(56 pages)
Space heaters AEG Lavamat 2002 User Manual
(47 pages)
(47 pages)
Space heaters AEG WKL 2502 User Manual
(124 pages)
(124 pages)
Space heaters AEG HG995440XB User Manual
(32 pages)
(32 pages)
Space heaters AEG HG654320NM User Manual
(76 pages)
(76 pages)
© 2020, manymanuals.com. All rights reserved. | 0.745 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals