AEG ARE I2 Operations Instructions download pdf (Page 30)

"UniVert 2" inverter

Page 30 of 42 8000012364 BAL, en

7 Troubleshooting

Attention! All work on the unit may be carried out by specially

trained qualified personnel only. Always observe the safety

instructions! (See chapter 1.)

7.1 No Output Voltage or Output Current Present

(with connected load)

Individual INV operation:

• DC present and correct polarity?

• Are the LCD and the fan working? (Control unit is supplied with

power)

• Is the INV switched on?

• Is the miniature circuit-breaker F1 switched on?

• Has a monitoring system responded?

(Switch the INV OFF and back ON)

With INVs in parallel operation: (additionally)

• LCD shows output voltage but no current:

AC fuse faulty? Check output voltage of the unit

INV does not synchronise and does not switch on the output

contactor

For systems with SBS: (additionally)

• LCD shows output voltage but no current:

INV does not synchronise and does not switch on the output

contactor

Is the SBS blocked?

If all aforementioned points are OK, proceed as follows:

• Disconnect the unit and disassemble it (see chapter 5.4)

• Unscrew the cover

• Observe the safety instructions!

• Check fuse F1 on printed circuit board A3.1 (softstart)

• Check fuse F100 on printed circuit board A17

(INV interface, auxiliary power supply)

• Check fuse F1 on printed circuit board A17

(INV interface, 24 V for fan, relay, INV control)

• Check plug connections for correct position

It the fault cannot be eliminated, return the unit to the works for repair

enclosing a fault description.

7.2 Output Voltage Deviation

• Did the INV cause the output voltage deviation?

• Is the unit running with current limiting due to overload?

Reduce the load!

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Comments to this Manuals

Arthur Norbisrath 02 Apr 2024 | 23:47:35

Hello trying to locate a table that defines the recommended servicing of A 60 KVA UPS system? 5.33/xxx-220 25KVA - 120kva Regards Arthur Norbisrath Snowy Hydro Australia Email. [email protected]

AEG ARE I2 Operations Instructions Page 30

Comments to this Manuals

Related products and manuals for Power supply units AEG ARE I2