AEG HK604200IB User Manual download pdf (Page 12)

Problem Possible cause Remedy

The sensor fields become

hot.

The cookware is too large or

you put it too near to the

controls.

Put large cookware on the

rear zones if possible.

comes on.

Automatic Switch Off oper-

ates.

Deactivate the hob and acti-

vate it again.

comes on.

The Child Safety Device or

the Lock function operates.

Refer to "Daily use" chapter.

comes on.

There is no cookware on the

zone.

Put cookware on the zone.

The cookware is incorrect. Use the correct cookware.

Refer to “Hints and tips”

chapter.

The diameter of the bottom

of the cookware is too small

for the zone.

Use cookware with correct

dimensions.

Refer to “Technical informa-

tion” chapter.

and a number come on.

There is an error in the hob. Disconnect the hob from the

electrical supply for some

time. Disconnect the fuse

from the electrical system of

the house. Connect it again.

If comes on again, speak

to an Authorised Service

Centre.

comes on.

There is an error in the hob

because a cookware boils

dry. Automatic Switch Off

and the overheating protec-

tion for the zones operate.

Deactivate the hob. Remove

the hot cookware. After ap-

proximately 30 seconds, acti-

vate the zone again. If the

cookware was the problem,

the error message goes out.

Residual heat indicator can

stay on. Let the cookware

become sufficiently cool.

Check if your cookware is

compatible with the hob.

Refer to “Hints and tips”

chapter.

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Give also

three digit letter code for the glass

ceramic (it is in the corner of the glass

surface) and an error message that

comes on. Make sure, you operated the

hob correctly. If not the servicing by a

service technician or dealer will not be

free of charge, also during the warranty

www.aeg.com12

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments