AEG FAV86050U-M User Manual download pdf (Page 11)

Operating Instructions

Set water softener

Using the table as a guide, adjust the water softener to that which cor-

responds to the hardness of the water in your area:

0 The dishwasher must be switched off.

Manual setting:

1. Open the dishwasher door.

2. Remove the lower rack from the

dishwasher.

3. Turn the hardness range switch to 0

or 1 (see table).

4. Replace the lower rack.

Electronic setting:

1. Press the ON/OFF button.

The LED in the ON/OFF button will become illuminated.

If other indicators are also illuminated, this means that a dishwashing

cycle has been activated. The dishwashing cycle must be cancelled

(RESET):

Press function buttons 1 and 2 simultaneously for approx. 2 seconds.

All other indicators will go out.

2. Press the function buttons 1 and 2 simultaneously and keep them

pressed.

The LED indicators in function buttons 1 to 3 will flash.

3. Press function button 1again.

The LED indicator for function button 1 will flash.

The multi-display will indicate the hardness setting.

4. Pressing function button 1 increases the hardness setting by 1 degree.

(Exception: hardness setting 1 follows hardness setting 10).

5. When the hardness setting is correct, press the ON/OFF button.

The hardness setting is now saved.

1) (°d) German degree, measure of the hardness of water

2) [mmol/l] millimol per litre, international unit for the hardness of water

3) On this setting the length of the dishwashing cycle may be slightly longer.

*) Factory setting

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

No comments

AEG FAV86050U-M User Manual Page 11