AEG BEB331010M User Manual download pdf (Page 25)

2. Pull it forwards against the spring

pressure and out of two holders.

The heating element folds down.

3. Clean the oven ceiling.

4. Install the heating element in the

opposite sequence.

Install the heating element

correctly above the supports

on the inner walls of the

appliance.

5.

Install the shelf supports.

11.5 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the oven at

an upwards angle.

5.

Put the door with the outer side

down on a soft cloth on a stable

surface.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

1

2

B

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

One of the hinge-arms

(normally the right one) is

free to move. Make sure,

that both hinge-arms are in

the same position

(approximately 70° angle).

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

ENGLISH 25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments