AEG LAV W1010-W User Manual download pdf (Page 29)

What to do, if…

29

Excessive foaming dur-

ing the main wash.

Probably too much detergent

was used

Dose detergent exactly in

accordance with the manu-

facturer’s instructions.

Water runs out from

under the washing

machine.

Threaded fitting on the

water inlet hose is leaking.

Tighten the water inlet hose

Drain hose is leaking.

Check drain hose and if nec-

essary replace.

Suds pump cover is not

closed properly.

Close cover properly.

Washing is trapped in the

door.

Stop program, remove wash-

ing from the door, start a

new program.

Softener is not washed

in, compartment w

for conditioner is full

with water.

Suction cap in the compart-

ment for conditioner is not

correctly positioned or is

blocked.

Clean detergent drawer,

place suction cap firmly in

position.

Appliance does not

spin, water in the

drum.

RINSE HOLD selected. Deselect RINSE HOLD.

Washing is not spun

properly, water is still

visible in the drum.

Drain hose is kinked. Remove kink.

Maximum pumping height

(drain height 1m above the

floor on which the machine

is standing) exceeded.

Please contact customer

service who have a retrofit

kit for pumping to heights of

greater than 1m.

Suds pump is blocked.

Switch off the machine and

unplug from the mains, clean

the suds pump.

In the case of siphon con-

nection: siphon is blocked.

Clean siphon.

It is not possible to

open the door.

The door is locked due to

safety reasons.

Wait 1-2 minutes after the

end of the program.

Rinse water is cloudy.

This probably due to a deter-

gent with a high silicate con-

tent.

No negative impact on the

rinsing results, possibly use

liquid detergent.

Malfunction Possible Cause Remedy

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments