AEG L98699FL2 User Manual

L 98699 FL2EN WASHING MACHINE USER MANUAL

•The time of delay– When you set the delayed start the time of the programme end in-creases by steps of 30 minutes till 10 hours and by steps of oneho

Rinse hold1) Only available for Spin/Drain programme.JThe default temperature of the programme.Cold washBUTTON HÖYRY 4Touch button 4 to set the steam

The appliance soaks the laundry at 30°Cfor about half an hour before to wash.SPIN BUTTON 11Touch button 11 to:• Decrease the maximum speed of thespin

WASHING PROGRAMMESProgrammeTemperatureType of loadWeight of loadProgrammedescriptionFunctionsCottons(Valko/Kirjo)95° - ColdWhite and colouredcotton wi

ProgrammeTemperatureType of loadWeight of loadProgrammedescriptionFunctionsDuvet(Peitot)60° - 30°Special programme forone synthetic blanket,duvet, bed

4) This program removes the micro-organisms thanks to the washing by 60°C and adds onrinse. In this way the action is more effective. Important! Put i

WOOLMARK CERTIFICATEThe wool wash of this machine has been testedand approved by The Woolmark Company forthe washing of wool containing garments la-be

BEFORE FIRST USE1.To activate the drain system, put 2 li-tre of water in the main wash com-partment of the detergent dispenser.2.Put a small quantity

USING THE APPLIANCE1.Open the water tap.2.Connect the mains plug to the mainssocket.ACTIVATING THE APPLIANCE AND SETTING A PROGRAMMEFor a correct oper

Make sure not to have the laundry out ofthe drum between the seal and the door.There is the risk of water leakage or dam-age laundry.FILLING THE DETER

CONTENTS4 SAFETY INFORMATION5 TECHNICAL INFORMATION7 PRODUCT DESCRIPTION7 INTERIOR ACCESSORIES8 CONTROL PANEL13 WASHING PROGRAMMES17 BEFORE FIRST USE1

Check the position of the flap1.Pull out the detergent dispenser untilit stops.2.Press the lever down to remove thedispenser.3.To use powder detergent

Before you touch button 6 tostart the appliance, you can cancelor change the set of the delaystart.You cannot set the delay start withthe Steam progra

5.The door lock symbol goes off.6.Press button 1 to deactivate the ap-pliance. After five minutes from theend of the programme, the AUTOOFF function a

HELPFUL HINTS AND TIPSTHE LAUNDRY LOAD• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that are

Level TypeWater hardness°dH °T.H. mmol/l Clarke2 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.7 17-254 very hard > 21 > 37 >3.7 &g

CARE AND CLEANINGWARNING!Disconnect the appliance from the mainssupply before you clean it.DESCALINGThe water we use contains limescale. If itbecomes

DETERGENT DISPENSERTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquid ad-ditive compartment.4.Cle

To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the

129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven

When you drain the water with the emer-gency drain procedure, you must activateagain the drain system:1.Put 2 litres of water in the main washcompartm

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

TROUBLESHOOTINGThe start of the appliance does not occuror it stops during operation.Try to find a solution to the problem be-fore you contact the ser

PROBLEM WITHOUT ALARM MESSAGEProblem Possible cause Possible solutionThe appliancedoes not drainthe water.A washing programmewithout the drain phaseis

Problem Possible cause Possible solution You did not remove thepackaging and/or thetransit bolts.Remove the packaging and/orthe transit bolts. Refer

INSTALLATIONSPECIAL ACCESSORIES FORINSTALLATIONFIXING PLATE KIT (405517114)Available from your authorized dealer.If you install the appliance on a pli

5.Open the door. Remove the polystyr-ene piece from the door seal and allthe items from the drum.6.Put one of the polystyrene packagingelements on the

AB9.Make sure to identify the differentsizes and the positions of the soundbarriers. Refer to the illustration:A (FRONT) = Front of the applianceB (BA

13.Turn the three bolts with the key sup-plied with the appliance. Pull out theplastic spacers.14.Put the plastic caps in the holes. Youcan find these

• The appliance must be level and stable.CAUTION!Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the level.THE INL

Water-stop deviceAThe inlet hose has a water stop device.This device prevents water leaks in thehose because of its natural ageing. Thered sector in t

Without the plastic hose guide.• To a sink spigot.Refer to the illustration. Put the drainhose in the spigot and tighten it with aclip. Make sure that

SAFETY INFORMATIONBefore the installation and use, read thismanual carefully:• For your safety and the safety of yourproperty• To help the environmen

www.aeg.com/shop 132924220-A-102012

To replace the internal lamp, con-tact the service centre.Disconnect the mains plug fromthe mains socket before the re-placement of the internal lamp.

Level of protection against ingress of solid particlesand moisture ensured by the protective cover, exceptwhere the low voltage equipment has no prote

PRODUCT DESCRIPTION1 2 3910578411121361Worktop2Detergent dispenser3Control panel4Door handle5Internal lamp6Rating plate7Drain pump8Feet for the applia

CONTROL PANELUlkoilupuvutVilla/Silkki1 2 36789101112451Auto Off button2Programme knob3Display4Steam touch button (Höyry)5Memory touch buttons (Muisti)

DISPLAY 3ABCDEFGHIJAThe text bar:• Guides you in the use of the appliance.• Shows the programme status and phase.• Shows alarm messages. Refer to &apo