AEG L87695WD User Manual download pdf (Page 42)

• Connect the water inlet hose to the

cold water tap with 3/4 thread.

CAUTION!

Make sure that there are no leaks

from the couplings.

Do not use an extension hose if

the inlet hose is too short. Contact

the service centre for the replace-

ment of the inlet hose.

Water pressure

The appliance works correctly if the water

pressure is not less than 0.05 MPa (0.5

bar).

If you can not connect the water inlet

hose to the cold water tap of the primary

hydraulic system, connect it to your do-

mestic cold water storage system.

Make sure not to have more than a dis-

tance of 5.02 m (16.5 ft) between the ap-

pliance inlet hose and the bottom of the

water storage tank.

Water-stop device

A

The inlet hose has a water stop device.

This device prevents water leaks in the

hose because of its natural ageing. The

red sector in the window «A» shows this

fault .

If this occur, close the water tap and con-

tact the service centre to replace the

hose.

WATER DRAINAGE

There are different procedures to connect

the drain hose:

With the plastic hose guide.

42

www.aeg.com

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments