AEG L87695NWD User Manual download pdf (Page 22)

The programme or the delay start

continues.

9.14 End of cycle

When the programme has finished, the

appliance stops automatically. The

acoustic signal operates (if it is active).

In the display comes on and the door

locked indicator

goes off.

The indicator of Départ/Pause button

goes off.

1. Press button Marche/Arrêt to

deactivate the appliance.

After five minutes from the end of the

programme, the energy saving function

automatically deactivates the appliance.

When you activate the

appliance again, the display

show the end of the last set

programme. Turn the

programme knob to set a

new cycle.

2.

Remove the laundry from the

appliance.

3. Make sure that the drum is empty.

4. Keep the door ajar, to prevent

mildew and odours

9.15 Draining water out after

end of cycle

The washing programme is completed,

but there is water in the drum:

The drum turns regularly to prevent the

creases in the laundry.

The door lock indicator

is on. The

door stays locked.

You must drain the water to open the

door:

1. If necessary, decrease the spin

speed.

2. Press the Départ/Pause button.

The appliance drains the water and

spins.

3. When the programme is completed

and the door lock indicator

goes

off, you can open the door .

4. Press Marche/Arrêt some seconds to

deactivate the appliance.

The appliance drains and

spins automatically after

approximately18 hours.

9.16 AUTO Stand-by option

The AUTO Stand-by function

automatically deactivates the appliance

to decrease the energy consumption

when:

• You do not use the appliance for 5

minutes before you press Départ/

Pause button.

Press the button Marche/Arrêt to

activate the appliance again.

• After 5 minutes from the end of the

washing programme

Press the button Marche/Arrêt to

activate the appliance again.

The display shows the end of the last

set programme.

Turn the programme knob to set a

new cycle.

If you set a programme or an

option that ends with water

in the drum, the AUTO

Stand-by function doesn't

deactivate the appliance to

remind you to drain the

water.

10. DAILY USE - DRYING ONLY

WARNING!

Refer to Safety chapters.

10.1 Preparation to drying

1. Press button Marche/Arrêt for some

seconds to activate the appliance

2. Load the laundry one item at a time.

3. Turn the programme dial to the

drying programme applicable for the

items to dry.

The display shows a minimum time value

and the following symbols:

www.aeg.com22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Comments to this Manuals

No comments