AEG CTV 4807 DVD Instruction Manual download pdf (Page 25)

Commissioning

Connecting to the mains

Attention!

Only connect the television set to the mains power supply

once you have properly connected it to all devices and the

antenna. The television set may otherwise be damaged.

 Insert the television set's mains plug into the mains socket.

Connecting a video camera

Attention!

Note the connection specifications in the operating

instructions for your camera under all circumstances.

 Insert the yellow, the black and the red cinch cables into the

"AV IN" connections on the side of the television set.

 Connect the cinch cable to your camera.

Video camera connection schematic

Commissioning

Remote control

The remote control requires two Mignon LR 6/AA/1.5 V batteries.

 Open the battery compartment.

 Insert two batteries into the battery compartment, observing

the specified polarity.

 Carefully close the battery compartment lid again until the lid

engages.

 Replace dying batteries within good time.

 Always replace both batteries at the same time and use

batteries of the same type.

 If a battery has leaked in the battery compartment, put on

protective gloves.

 Remove both batteries from the battery compartment and

clean the battery compartment with a dry cloth.

Attention!

Batteries may contain toxins which cause damage to health

and to the environment. Batteries must therefore be disposed

of according to the applicable legal regulations under all

circumstances. Never dispose of batteries in normal domestic

waste.

 Dispose of the leaked batteries.

The remote control transmits infrared signals to the television set.

Please refer to the following chapter, "Remote control button

assignment" for the button functions.

 Point the remote control at the front of the television set and

briefly press the corresponding button once.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

No comments

AEG CTV 4807 DVD Instruction Manual Page 25