AEG WSP 5010 User Manual download pdf (Page 18)

1. Operating Instructions

1.1 Functional Principle

The supplementary heater installed in the storage heater enables the room to be heated

independently of the charging of the storage heater.

In the transitional period, for example, the heating requirements on cool days can be covered by

the supplementary heater alone, i.e. without charging the storage heater.

If the stored heat is no longer sufficient when it suddenly gets cold in the evening, the

supplementary heater can be switched on for support. The supplementary heater does not come

into action as long as there is enough stored heat. Operation of the supplementary heater would

be uneconomical in this case.

The supplementary heater is only operated with the fan running and is connected to this at the

discharge unit of the storage heater (230 V).

The electricity costs are totalled by the main tariff meter.

1.2 Operation

. . . with separate room temperature regulator

When using a room temperature regulator without supplementary heater switch, the

supplementary heater can be switched by the ON/OFF switch (S1) to be installed in the control

panel.

In the case of a room temperature regulator with supplementary heater switch, the supplementary

heater is switched on/off with this switch (no ON/OFF switch is necessary in the control panel).

. . . with built-in room temperature regulator

If the unit is controlled by the built-in room temperature regulator RTi 102 E or RTi 103 EP, the

supplementary heater is switched with the ON/OFF switch provided.

When operating with a RTi 103 EP (proportional controller) it should be noted that this regulator

becomes a 2-position controller after switching on the supplementary heater.

Observe the operating and installation instructions of the room temperature regulator!

For the User

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

No comments

AEG WSP 5010 User Manual Page 18