AEG SNMP Network Adaptor User Manual download pdf (Page 59)

6.3.4 Configuration

For setting up the sensors in the SensorMan make sure your configuration matches your

sensor type, e.g. see example:

Figure 58: HTTP - SENSORMANAGER Settings

Using the splitting plugs (Part NO.SPSMRJ) it is possible to connect up to 8 sensors and 4

contacts to the SensorMan. A Mounting Kit (sold separately) is available for affixing the

SensorMan to walls and railings.

The power supply for the SensorMan may also supply an external CS121 using a SM-CS121

type cable (sold separately) by simply connecting the Power-out of the SensorMan with the

Power-in of the CS121 external.

Note: A combination of CS121 – SITESWITCH 4 SENSORMANAGER in a

compact chassis is the SITEMANAGER – for more information about

this Rackmonitoring and management device please refer to GENEREX

website.

• Startup the Sensor Manager:

Connect the sensors to the SensorMan. Connect the SensorMan using the Mini8-DBSub9

cable to the COM 2 port of the CS121. Finally, plug the power supply into one of the UPS

power outlets. Check the green LEDs on the bottom of the SensorMan; one should be flashing

when reading data, and the other should be constantly lit. The flashing LED shows the

requests from the CS121 – this means the installation is OK. The other LED shows that the

device has started.

Note: You have to configure the CS121 COM2 port to “SensorMan” –

otherwise the CS121 will not start making requests to the Sensor

Manager.

When the SENSORMANAGER is running, you will see the values in the AUX section of the

CS121 Web browser.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 77 78

No comments

AEG SNMP Network Adaptor User Manual Page 59