AEG HK854326IB User Manual download pdf (Page 17)

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in

units and work surfaces that align to the

standards.

8.3 Connection cable

• The hob is supplied with the

connection cable.

• Replace the damaged mains cable

only with the spare parts cable. Speak

to your local Authorised Service

Center.

WARNING!

All electrical connections

must be made by a qualified

electrician.

CAUTION!

Do not drill or solder the

wire ends. This is strictly

forbidden!

CAUTION!

Do not connect the cable

without cable end sleeve.

Two-phase connection

1. Remove the cable end sleeve from

black and brown wires.

2. Remove an insulation of the brown

and black cable ends.

3. Apply a new wire end sleeve of 1.5

mm² on each cable end. (special tool

required).

Cable cross section

230V~ 400V 2~N

One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N

Green - yellow Green - yellow

N Blue and blue Blue and blue N

L Black and brown Black L1

Brown L2

8.4 Attaching the seal to the

rabbet

1. Clean the rabbets in the worktop.

2. Cut the supplied seal stripe into 4

stripes. The stripes must have the

same length as the rabbets.

3. Cut the ends of the stripes at an

angle of 45°. They should fit in the

corners of the rabbets accurately.

4. Attach the stripes to the rabbets. Do

not extend the stripes. Do not bond

ends of stripes one over another.

ENGLISH 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 67 68

Comments to this Manuals

No comments

AEG HK854326IB User Manual Page 17

Comments to this Manuals

Related products and manuals for Hobs AEG HK854326IB