AEG FFB83730PW User Manual

USER MANUALEN User ManualDishwasherFFB83730PW

5.2 Information for testinstitutesFor all the necessary information for testperformance, send an email to:[email protected] dow

German de-grees (°dH)French degrees(°fH)mmol/l Clarke de-greesWater softener lev-el15 - 18 26 - 32 2.6 - 3.2 18 - 22 411 - 14 19 - 25 1.9 - 2.5 13 - 1

• The indicators , and are off.• The indicator still flashes.• The display shows the currentsetting: e.g. = level 4.– The levels of rinse aid ra

Not all options arecompatible with each other.If you select non compatibleoptions, the applianceautomatically deactivatesone or more of them. Onlythe

8.1 The salt containerCAUTION!Use rough salt designed fordishwashers only. Fine saltincreases the risk ofcorrosion.The salt is used to recharge the re

9. DAILY USE1. Open the water tap.2. Press the on/off button to activatethe appliance.Make sure that the appliance is inprogramme selection mode.• If

If the door is opened formore than 30 secondsduring the drying phase, therunning programme ends. Itdoes not happen if the dooris opened by AirDryfunct

10.2 Using salt, rinse aid anddetergent• Only use salt, rinse aid and detergentfor dishwasher. Other products cancause damage to the appliance.• In ar

11. CARE AND CLEANINGWARNING!Before maintenance,deactivate the appliance anddisconnect the mains plugfrom the main socket.Dirty filters and cloggedspr

CAUTION!An incorrect position of thefilters can cause badwashing results and damageto the appliance.11.2 Cleaning the upper sprayarmWe recommend to cl

CONTENTS1. SAFETY INFORMATION...22. SAFETY INSTRUCTIONS...

• Using short-duration programmesregularly can cause grease andlimescale buildup inside theappliance. Run long-durationprogrammes at least twice a mon

Problem and alarm code Possible cause and solutionThe programme lasts toolong.• If the delay start option is set, cancel the delay setting orwait for

Problem Possible cause and solutionPoor drying results. • Tableware has been left for too long inside a closedappliance.• There is no rinse aid or the

Problem Possible cause and solutionLimescale deposits on the ta-bleware, on the tub and onthe inside of the door.• The level of salt is low, check the

14. ENVIRONMENTAL CONCERNSRecycle materials with the symbol .Put the packaging in relevant containersto recycle it. Help protect theenvironment and h

ENGLISH 25

www.aeg.com26

ENGLISH 27

www.aeg.com/shop117873370-A-492017

manufacturer is not responsible for any injuries ordamages that are the result of incorrect installation orusage. Always keep the instructions in a sa

• If the supply cord is damaged, it must be replaced bythe manufacturer, its Authorised Service Centre orsimilarly qualified persons in order to avoid

fuse, use only a 13 A ASTA (BS 1362)fuse.2.3 Water connection• Do not cause damage to the waterhoses.• Before connection to new pipes,pipes not used f

3. PRODUCT DESCRIPTION65911 10 7812 13 34211Worktop2Top spray arm3Upper spray arm4Lower spray arm5Filters6Rating plate7Salt container8Air vent9Rinse a

4. CONTROL PANEL12 4 5378 61On/off button2Program button3Programme indicators4Display5Delay button6Option button7Indicators8Start button4.1 Indicators

Indicator DescriptionDelay indicator.ExtraHygiene indicator.5. PROGRAMMESProgramme Degree of soilType of loadProgramme phases Options 1)• Normal soil•

Programme Degree of soilType of loadProgramme phases Options 8)• Normal soil• Crockery andcutlery• Prewash• Wash 50 °C• Rinses• Dry• XtraDry1) This pr