AEG LP 10.0 Operations Instructions download pdf (Page 30)

Step 11: Charging complete

L. Once the battery charge is at 100 % the

display will read . Charging will now be

stopped and the battery can be disconnected

from the charger. Always first disconnect the

power cable from the mains current.

Then disconnect the negative (-) black clamp

from the negative (-) battery terminal. Finally,

disconnect the positive (+) red clamp from the

positive (+) battery terminal.

Step 10: Trickle charging mode

K. Once the battery is almost fully charged the

charger will activate “Trickle Charging“ mode.

The voltage and amperage will now be adjusted

for the charging process. The display will read

Step 9: Slow charging

J. Once the battery charge reaches 90 % the

equipment automatically switches to slow charge.

The remaining capacity will now be gently

charged at a lower voltage. This mode will be

indicated by and the battery charging

bar .

Step 8: Charging

G, H, I. The respective battery voltage of 6, 12

or 24 V will briefly be displayed. The charger

will start charging and the display will read

for some time. After charging to 10 % will be

displayed, charging will now continue in rapid

mode until the display reads to confirm the

charge has reached a level of 90 %.

Step 7: Battery voltage recognised

D, E, F. If the equipment automatically detects an

operating voltage of 6, 12 or 24 V, this infor-

mation will be shown in the display. For a 12 V

battery, for example, the display will briefly read

. The battery condition will also be shown.

Charging will start after this battery review.

T. If the battery voltage is between 1.5 V and

3.5 V the charger will attempt to increase the

voltage within a few minutes so that regular

charging can automatically be continued. If this

fails the display will read and charging will

be suspended. However, since the equipment

detected a proper connection with the battery no

further steps may be taken. The battery is

defective and can no longer be charged!

100

97100_Ladeger󾜀t _LP_10.0 Manual _09_12_2011_print

Freitag, 9. Dezember 2011 11:11:32

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 97 98

Comments to this Manuals

No comments

AEG LP 10.0 Operations Instructions Page 30

Comments to this Manuals