AEG LAV41380 User Manual download pdf (Page 43)

Water connections

The washing machine is provided with safety equipment that prevents

dirty water from flowing backwards into the drinking water supply pipes,

in accordance with national water company specifications. Therefore

there is no need to use any other additional protection in the installation.

Warning! Washing machines designed to be connected to a cold water

pipe must not be supplied with hot water!

Allowable water pressure

The water pressure shall be not less than 0,5 bar (= 0,05 MPa) and not more than

8 bar (

= 0,8 MPa).

Install a pressure reducer if the pressure exceeds 8

bar.

If the pressure is below 0,5 bar, unscrew the supply

pipe on the magnetic inlet valve on the washing

machine, and remove the flow regulator (to do this,

you will need to remove the filter using pliers, and

then rubber washer under it). Then put the filter

back into position. This work can only be done by a qualified installer.

Water supply

A 1.5 m long supply pipe is provided with the washing machine.

If you need to use a longer supply pipe, only use a complete set of pipes

fitted with installed screw-on end pieces, supplied by our After Sales

Service.

Warning! Never use odd pieces of pipe as extensions!

Sealing rings are supplied either inside the plastic nuts, or with the

accessories supplied with the washing machine. Do not use other sealing

rings!

Installation and connection instructions

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

No comments

AEG LAV41380 User Manual Page 43