AEG L9FEA966C User Manual Page 50

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 49
Problem Possible solution
The washing results are
not satisfactory.
Increase the detergent quantity or use a different deter-
gent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that no other type of detergent has been poured
the compartment
Salt
. In this case, refer to "Eliminating de-
tergent or other additives from salt compartment'.
Make sure that no salt has been poured in the compart-
ment . If it happens, run a rinse cycle or run the washing
cycle again.
Too much foam in the
drum during the washing
cycle.
Reduce the quantity of detergent.
Excessive liquid leakage
form the detergent dis-
penser.
Make sure that the rubber brushes under the detergent
compartment are intact.
Excessive consumption
of salt.
Check if the water softener has been set to act also during
rinse phase. Refer to "How to set the water hardness level"
in "The Water Softener (SoftWater Technology)" chapter.
The drum is empty and
the display shows there is
some weight in.
Press the On/Off button to deactivate the appliance and
activate it again to set a tare.
The drum is full but the
display shows 0.0 kg.
You loaded the laundry before activating the appliance.
Press the On/Off button to deactivate the appliance.
Empty the drum and follow the necessary steps. (Refer to
"Loading the laundry")
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
17.3 Emergency door opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water
temperature is not too
high and the laundry is not
hot. If necessary, wait until
they cool down.
www.aeg.com50
Page view 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments