AEG L99695HWD User Manual download pdf (Page 33)

compartment of the detergent

dispenser.

2. Start the programme to drain the

water

14.10 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0° C, remove the remaining water from

the inlet hose and the drain pump.

1. Disconnect the mains plug from the

mains socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in

a container and let the water flow out

of the hose.

4. Empty the drain pump. Refer to the

emergency drain procedure.

5. When the drain pump is empty,

install the inlet hose again.

WARNING!

Make sure that the

temperature is more than 0

°C before you use the

appliance again. The

manufacturer is not

responsible for damages

caused by low temperatures.

15. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

15.1 Introduction

The start of the appliance does not occur or it stops during operation.

First try to find a solution to the problem (refer to the table). If not, contact the Authorised

Service Centre.

With some problems, the acoustic signals operate and the display shows an alarm

message:

CAUTION!

Deactivate the appliance before you do the checks.

15.2 Possible failures

Problems with alarm messages

Message Possible solution

The display tells to check the

tap: the appliance does not

fill with water.

Make sure that the water tap is open.

Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authori-

ty.

Make sure that the water tap is not clogged or is furred

with lime-scale.

Make sure that the filter of the inlet hose and the filter of

the valve are not clogged. Refer to “Care and cleaning”.

Make sure that the inlet hose is not damaged.

ENGLISH 33

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Comments to this Manuals

No comments

AEG L99695HWD User Manual Page 33

Comments to this Manuals

Related products and manuals for Washing machines AEG L99695HWD