AEG L99695HWD User Manual download pdf (Page 4)

side, where the appliance door can not be fully

opened.

• Connect the mains plug to the mains socket only at

the end of the installation. Make sure that there is

access to the mains plug after the installation.

• The ventilation openings in the base (if applicable)

must not be obstructed by a carpet.

• Ensure you have good ventilation in the installation

room to avoid the back flow of gases into the room

from appliances burning other fuels, including open

fires.

• Exhaust air must not be discharged into a flue which is

used for exhausting fumes from appliances burning

gas or other fuels (if applicable).

• The operating water pressure (minimum and

maximum) must be between 0,5 bar (0,05 MPa) and 8

bar (0,8 MPa).

• Obey the maximum load volume of 9 kg (refer to the

“Programme chart” chapter).

• The appliance is to be connected to the water mains

using the new supplied hose-sets. Old hose sets must

not be reused.

• If the supply cord is damaged, it must be replaced by

the manufacturer, its Authorised Service Centre or

similarly qualified persons in order to avoid a hazard.

• Wipe away lint that has accumulated around the

appliance.

• Do not run the appliance without filters. Clean the lint

filter before or after each use.

• Items that have been soiled with substances such as

cooking oil, acetone, alcohol, petrol, kerosene, spot

removers, turpentine, waxes and wax removers should

be washed in hot water with an extra amount of

detergent before being dried in the wash dryer.

• Do not use the appliance if industrial chemicals have

been used for cleaning.

• Do not dry unwashed items in the wash dryer.

www.aeg.com

1 2 3 4 5 6 7 8 9 ... 47 48

No comments

AEG L99695HWD User Manual Page 4