AEG L87695WD User Manual download pdf (Page 30)

To clean the water inlet filters:

1.

Close the water tap.

2.

Remove the water inlet hose from

the water tap.

3.

Clean the filter in the inlet hose with

a stiff brush.

4.

Remove the inlet hose behind the

appliance.

5.

Clean the filter in the valve with a

stiff brush or a towel.

45°

20°

6.

Install again the inlet hose. Make

sure that the couplings are tight to

prevent leakages.

7.

Open the water tap.

18.9 Emergency drain

Because of a malfunction, the appliance

cannot drain the water.

If this occurs, do steps (1) through (6) of

'To clean the drain pump'.

If necessary, clean the pump.

Put the drainage duct back and close the

drain pump flap.

When you drain the water with the emer-

gency drain procedure, you must acti-

vate again the drain system:

1.

Put 2 litres of water in the main wash

compartment of the detergent dis-

penser.

2.

Start the programme to drain the

water.

18.10 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0 °C, remove the remaining water from

the inlet hose and the drain pump.

1.

Disconnect the mains plug from the

mains socket.

2.

Close the water tap.

3.

Remove the water inlet hose

4.

Put the two ends of the inlet hose in

a container and let the water flow

out of the hose.

5.

Empty the drain pump. Refer to the

emergency drain procedure

6.

When the drain pump is empty, in-

stall the inlet hose again.

WARNING!

Make sure that the temperature

is more than 0 °C before you use

the appliance again.

The manufacturer is not responsi-

ble for damages caused by low

temperatures.

30

www.aeg.com

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 83 84

Comments to this Manuals

No comments