AEG L74480DFL User Manual download pdf (Page 16)

Use this option for laundry with hard

stains to remove.

When you set this option, put the stain

remover into compartment .

This option increases the

programme duration.

This option is not available

with a temperature lower

than 40 °C.

8.7 T./min

With this option you can decrease the

default spin speed.

The display shows the indicator of the set

speed.

Additional spin options:

No Spin

• Set this option to remove all spin

phases.

• Set it for very delicate fabrics.

• To compensate the absence of

spinning, the rinse phase uses more

water for some washing programmes.

• The display shows the indicator

.

Rinse Hold

• Set this option to prevent the laundry

creases.

• The washing programme stops with

the water in the drum. The drum turns

regularly to prevent the laundry

creases.

• The door stays locked. You must drain

the water to unlock the door.

• The display shows the indicator

.

To drain the water refer to

"At the end of the

programme".

8.8 Temp.°C

Set this option to change the default

temperature.

Indicator = cold water.

The display shows the set temperature.

9. BEFORE FIRST USE

1. Put 2 litre of water in the detergent

compartment for washing phase.

This activates the drain system.

2. Put a small quantity of detergent in

the compartment for washing phase.

3. Set and start a programme for cotton

at the highest temperature without

laundry.

This removes all possible dirt from the

drum and the tub.

10. DAILY USE

10.1 Activating the appliance

1. Connect the mains plug to the mains

socket.

2. Open the water tap.

3. Press button Aan/Uit - Marche/Arrêt

to activate the appliance.

A short tune sounds.

10.2 Loading the laundry

1. Open the appliance door

2. Put the laundry in the drum, one item

at a time.

3. Shake the items before you put them

in the appliance.

Make sure not to put too much laundry

in the drum.

4. Close the door firmly.

www.aeg.com16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Comments to this Manuals

No comments