AEG L6FBI941N User Manual

USER MANUALEN User ManualWashing MachineL6FBI941N

The end of the drain hosemust always be ventilated ,i.e. the inner diameter of thedrain pipe (min. 38 mm -min. 1.5") must be largerthan the exter

4.2 Appliance overview1 2 39567410811 121Worktop2Detergent dispenser3Control panel4Door handle5Rating plate6Drain pump filter7Feet for levelling the a

1Programme dial2Display3Delay Start touch button4Time Save touch button5Start/Pause touch button6Options touch button• Stains option• Prewash option•

For more details, refer to Stand-byparagraph in Daily Use chapter.6.2 IntroductionThe options/functions arenot selectable with allwashing programmes.

Touch repeatedly the button to set therequired delay. The time increases bysteps of 30 minutes up to 90' and from 2hours up to 20 h.The indicator

Programme Programme description20 min. - 3 kgCotton and synthetic items lightly soiled or once worn.Cotton 20°Mixed fabric (cotton and synthetic items

Programme Default tempera-tureTemperaturerangeMaximum spin speedSpin speed rangeMaximum loadDuvet40 °C60 °C - Cold800 rpm800 rpm - 800 rpm3 kgEasy Iro

7.2 Woolmark Apparel Care -BlueThe wool wash cycle of this machine hasbeen approved by The WoolmarkCompany for the washing of woolgarments labelled as

10. DAILY USEWARNING!Refer to Safety chapters.10.1 Activating the appliance1. Connect the mains plug to the mainssocket.2. Open the water tap.3. Press

123. To use powder detergent, turn theflap up.4. To use liquid detergent, turn the flapdown.With the flap in theposition DOWN:• Do not usegelatinous o

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...

10.6 Starting a programmewith the delay startTouch the Start/Pause button.The appliance starts the countdown ofthe delay start.When the countdown is c

If the ProSense phase isalready carried out and thewater filling is alreadystarted, the new programmestarts without repeatingthe ProSense phase. Thewa

• After 5 minutes from the end of thewashing programmePress the On/Off button to activatethe appliance again.The display shows the end of the lastset

11.4 Ecological hints• Set a programme without theprewash phase to wash laundry withnormal soil.• Always start a washing programmewith the maximum loa

For a complete cleaning:1. Clean the drum with special productsfor stainless steel.Always follow theinstructions that you find onthe packaging of thep

Clean the drain pump if:• The appliance does not drain thewater.• The drum does not turn.• The appliance makes an unusualnoise because of the blockage

10. Clean the filter under the water tap.11. Put the filter back into the specialguides by turning it clockwise. Makesure that you tighten the filterc

45°20°12.9 Emergency drainIf the appliance cannot drain the water,carry out the same procedure, describedin 'Cleaning the drain filter' para

The programme was not finishedproperly or the appliance stoppedtoo early. If the alarm code appearsagain, contact the Authorised ServiceCentre.WARNING

Problem Possible solutionThere is water on thefloor.• Make sure that the couplings of the water hoses are tightand there is not water leakages.• Make

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f

14. CONSUMPTION VALUESStated values are obtained in laboratory conditions with relevant stand-ards. Different causes can change the data: the quantity

15. TECHNICAL DATADimension Width/ Height/ Depth/Total depth600 mm/ 850 mm/ 630 mm/ 660 mmElectrical connection VoltageOverall powerFuseFrequency230-2

using the correct stacking kitmanufactured and approved by AEG.Verify the compatiblestacking kit by checking thedepth of your appliances.The stacking

ENGLISH 33

www.aeg.com34

ENGLISH 35

www.aeg.com/shop192947831-A-242017

• The appliance must be connected to the water mainsusing the new supplied hose sets, or other new hosesets supplied by the Authorised Service Centre.

electrical ratings of the mains powersupply.• Do not use multi-plug adapters andextension cables.• Make sure not to cause damage tothe mains plug and

3. INSTALLATIONWARNING!Refer to Safety chapters.3.1 UnpackingWARNING!Remove all the packagingand the transit bolts beforeinstalling the appliance.WARN

CAUTION!Do not use alcohol, solventsor chemical products.9. Make sure to identify the differentsizes and the positions of the soundbarriers. Refer to

We recommend that youkeep the packaging and thetransit bolts for anymovement of the appliance.3.2 Installation on suspendedflooringSuspended wooden fl

20O20O45O45OMake sure that the inlet hoseis not in vertical position.3. If necessary, loose the ring nut to setit in the correct position.4. Connect t