AEG L60260TL1 User Manual download pdf (Page 19)

90˚

6.

Install again the inlet hose. Make

sure that the couplings are tight to

prevent leakages.

7.

Open the water tap.

11.7 Emergency drain

Because of a malfunction, the appliance

cannot drain the water.

If this occurs, do steps (1) through (3) of

'To clean the drain filter'.

If necessary, clean the filter.

Put the drainage duct back and close the

drain filter flap.

11.8 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0 °C, remove the remaining water from

the inlet hose and the drain pump.

1.

Close the water tap and disconnect

the inlet hose.

2.

Put the end of the inlet hose in a

container and let the water flow out

of the hose.

3.

Do the Drain programme and let it

operate until the end of the cycle.

4.

Turn the programme knob to Stop

to disconnect the appliance from the

power supply.

5.

Disconnect the appliance.

WARNING!

Make sure that the temperature

is more than 0 °C before you use

the appliance again.

The manufacturer is not responsi-

ble for damages caused by low

temperatures.

12. TROUBLESHOOTING

The start of the appliance does not oc-

cur or it stops during operation.

First try to find a solution to the problem

(refer to the table). If not, contact the

service centre.

With some problems, the acoustic

signals operate and the display shows

an alarm code:

•

- The appliance does not fill with

water.

•

- The appliance does not drain

the water.

•

- The appliance door is open or

not closed correctly.

•

- The anti-flood device is on.

WARNING!

Deactivate the appliance before

you do the checks.

Problem Possible cause Possible solution

The appliance

does not fill with

water.

The water tap is closed. Open the water tap.

ENGLISH 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments