L 87680 FL EN User manualDownloaded From WashingMachine-Manual.com Manuals
when you have laundry with a high lev-el of soil.The set of this function increasesthe programme duration.6.9 Spin button 9Press this button to:• Decr
7. PROGRAMMESProgrammeTemperatureType of loadMax. weight of loadCycledescrip-tionFunctionsAðalþvottur95° - ColdWhite and coloured cottonwith normal so
ProgrammeTemperatureType of loadMax. weight of loadCycledescrip-tionFunctionsOfnæmisvörn60°White cotton items.This programme removes mi-cro-organisms
3) If you set the Extra Quick duration, we recommend that you reduce the maximum load.It is possible to load fully the appliance, however the washing
Programmes Load(Kg)Energy con-sumption(kWh)Water con-sumption (li-tre)Approxi-mate pro-grammeduration(minutes)Remainingmoisture(%)1)Cottons 60°C8 1.50
11. LOADING THE LAUNDRY1.Open the appliance door.2.Put the laundry in the drum, oneitem at a time. Shake the items be-fore you put them in the applian
This is the maximum level for the quantity of liquid additives.The compartment for the stain remover.Put the product in the compartment and set the st
5.Measure out the detergent and thefabric conditioner.6.Carefully close the detergent dis-penser. Make sure that the flapdoes not cause a blockage whe
13.5 Cancel the delay start1.Press button 4 . The related indica-tor flashes.2.Press button 5 again and again un-til the display shows 0’.3.Press butt
15. HINTS AND TIPS15.1 The laundry load• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that ar
CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. TECHNICAL I
Water hardness tableLevel TypeWater hardness°dH °T.H. mmol/l Clarke1 soft 0-7 0-15 0-1.5 0-92 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.
16.6 Detergent dispenserTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquidadditive compartment.4.
To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the
129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven
Put the drainage duct back and close thedrain pump flap.When you drain the water with the emer-gency drain procedure, you must acti-vate again the dra
Problem Possible cause Possible solutionThe appliancedoes not drain thewater.The water drain hose isdamaged.Make sure that the water drainhose has no
Problem Possible cause Possible solution Leakages from the drainpump.Make sure that the drain pumpfilter is tight. The water drain hose isdamaged.Ma
18.2 Unpacking1.Use the gloves. Remove the externalfilm. If necessary, use a cutter.2.Remove the cardboard top.3.Remove the polystyrene packagingmater
6.Put one of the polystyrene packag-ing elements on the floor behindthe appliance. Carefully put downthe appliance with the rear side onit. Make sure
12.Put the plastic caps in the holes.You can find these caps in the usermanual bag.WARNING!Remove all the packaging andthe transit bolts before you in
1. SAFETY INFORMATIONBefore the installation and use, read thismanual carefully:• For your safety and the safety of yourproperty• To help the environ
18.4 The inlet hose20O20O20O45O45O45O• Connect the hose to the appliance.Turn the inlet hose only left or right.Loose the ring nut to set it in the co
With the plastic hose guide. • On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the
You can extend the drain hose tomaximum 400 cm. Contact theservice centre for the other drainhose and the extension.19. ENVIRONMENT CONCERNSRecycle th
ENGLISH 33Downloaded From WashingMachine-Manual.com Manuals
34www.aeg.comDownloaded From WashingMachine-Manual.com Manuals
ENGLISH 35Downloaded From WashingMachine-Manual.com Manuals
www.aeg.com/shop132928430-B-182012Downloaded From WashingMachine-Manual.com Manuals
• Do not install and connect a damagedappliance.• Make sure to remove all packagingand transport bolts.• Make sure that the mains plug is dis-connecte
Water supply pressure Minimum 0,5 bar (0,05 MPa)Maximum 8 bar (0,8 MPa)Water supply 1) Cold waterMaximum load Cotton 8 kgSpin speed Maximum 1600 rpm1
4. ACCESSORIES1 2341SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear sideof the cabinet after the removal ofthe transit
6.1 AUTO Off button 1Press this button to activate or deacti-vate the appliance. A tune sounds whenthe appliance is activated.The AUTO OFF function au
The phase symbols• When a programme is set, all the symbols of the phases related tothe programme come on.• When the programme starts, only the symbol
If you make a wrong selection the message Err indicates that the selec-tion is not possible.JThe time save symbol comes on when you set one of theprog
Comments to this Manuals