AEG PORSZIVO RF AVQ2270 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 7
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
8
9
32
33+34
34
35
* Certain models only.
36
38
37
39
40
41
42
* Certain models only.
English
Cleaning the hose and nozzle
The vacuum cleaner stops automatically if the nozzle,
tube, hose or filters and s-bag® becomes blocked. In
such cases, disconnect from mains and allow to cool
for 20-30 minutes. Clear blockage and/or replace
filters and s-bag® and restart.
Tubes and hoses
36 Use a cleaning strip or similar to clear the tubes
and hose.
37 Hose handle could be dismantled from hose if
cleaning is needed.
38 It may also be possible to remove the obstruction
in the hose by squeezing it. However, be careful
in case the obstruction is caused by glass or
needles caught inside the hose.
Note: The warranty does not cover any damage to the
hose caused by cleaning it.
Cleaning the floor nozzle
39 Be sure to frequently clean the combination
floor nozzle.
40* Press each wheel-hub and draw away the wheels.
Remove dust-balls, hair or other objects that
may be entangled.
41* Larger objects can be accessed by removing the
connection tube from the nozzle.
Cleaning the turbo nozzle*
42 Disconnect the nozzle from the vacuum cleaner
tube and remove entangled threads, etc. by
snipping them away with scissors. Use the hose
handle to clean the nozzle.
English
Replacement of the motor filter
Should be done with every 5th replacement of the
dust bag, s-bag®. Never use the vacuum cleaner
without filter(s).
Note. Before changing motor filter – check if your Viva
Quickstop is equipped with an exhaust-filter or not.
A Model without exhaust filter has to be equipped
with a combination-filter (motor + micro filter).
Ref. No. EF 74).
32 Open the front lid and lift out the insert holding
the s-bag®.
33 Pull the filter holder upwards until coming away
from the groove.
34 Carefully pull the old, dirty filter out of the filter
holder and replace with a new filter (white side
towards filter holder, black side towards the
motor). Reattach the filter holder containing the
new filter. Replace the insert holding the s-bag®
and then close the lid.
B Model with exhaust filter: Follow steps 32-34
and replace old motor filter.
Replacement of the exhaust filter*
There are three types of exhaust filter:
Micro filter* (Ref. No. EF 17)
Hepa H12* non washable (Ref. No. EF H12)
Hepa H12* washable (can be bought as an option,
Ref. No. EF H12W)
The filters must always be replaced with new ones and
cannot be washed (except the Hepa H12* washable).
35 Open the back lid and lift out the filter. Insert a
new filter and close the lid.
* 특정 모델에만 해당
한국
모터보호 필터 교
모터보호 필터는 먼지봉투 5번 교환할 마다
번씩 환해 주어야 합니다. 모터보호 필터
없이는 절대로 청소기를 사용하지 마십시오.
주의:보호 필터를 교하기 전- 사용중
모델의 배기필터 유무를 확인하십시오.
A 배기 필터가 ‘없는’ 모델 경우 콤비필터
(모터 + 마이크로 필터: Ref. No. EF 74)가
장되어 있습니다.
32 커버를먼지봉투 더를 꺼내세요
33 필터 홀더를 위쪽으로 당겨 홈에서 빼냅니다.
34 사용한 필터를 조심스럽게 당겨서 꺼낸
다음 필터로 교환해 주십시오.
(흰색면은 홀더쪽으로 은색면은 모터쪽으로)
필터를 필터홀더를 다시 제자리에
하여 주십시오. 먼지봉투 홀더를 제자
리에 넣고 커버를 닫아 주십시오.
B 배기 필터가 ‘있는’ 모델 경우: 위에 설명한
32~34단계에 따르고 사용한 모터보호 필터
교환하여 주십시오.
배기 필터* 교
배기 필터에는 3가지 종류가 있습니다.
• 마이크로 필터*(Ref. No. EF 17)
비세 헤파 H12*(Ref. No. EF H12)
• 세척 헤파 H12*(Ref. No. EF H12W, 옵션으로
구입가능)
세척 헤파 H12*를 제외하고는 세척할 으며
반드시 새것으로 주어 합니다.
35 뚜껑을 열고 필터를 내십시오.
새 필터를 삽입하고 뚜껑을 닫 두십시오.
* 특정 모델에만 해당
한국
호스 및 노즐 청소
노즐, 튜브, 호스 또는 필터 먼지봉투가 막히면
공 청소기 자동으로 정지됩니다. 이 같은
에는 플러그를 뽑 차단한 다음
20-30 정도 열을 식혀 십시오. 막힌 부분을
뚫어 주거나 또는 필터와 먼지봉투를 교환한 다음
가동 십시오.
튜브 호스
36 튜브와 호스를 청소할 때는 깨끗하고 헝겊
사용하여 십시오.
37 호스 손잡이를 청소할 때는 호스와 분리한
청소할 수도 있습니다.
38 호스를 부드럽게 비틀어 주어 호스내의
제거할 수도 있습니다. 그러나 호스 유리
조각이나 바늘 등이 걸린 경우에는 주의해야
니다.
주의: 호스 청소시 부주의에 의한 손상에 대해서
는 보증이 적용되지 않습니다.
일반 바닥용 헤드(노즐) 청소
39 콤비 바닥용 노즐은 자주 청소해야 합니다.
40* 바퀴축을 눌러 바퀴를 떼어 십시오. 뭉친
지나, 머리카락 또는 기타 엉킨 것들을 제거
하여 주십시오.
41* 중간에 걸려있는 커다란 물체는 노즐 튜브를
분리하여 제거할 수 있습니다.
터보 노즐* 청소
42 진공 청소기 튜브에서 노즐을 분리한 다음 엉킨
같은 부분은 가위로 라내 제거하십시오.
노즐을 청소할 때는 호스 손잡이를 용하
편리합니다.
ELX9575_Eng_Chorean.indd 8-9 6/28/06 2:39:21 PM
Page view 4
1 2 3 4 5 6 7

Comments to this Manuals

No comments