AEG T76288AC User Manual download pdf (Page 44)

12. INSTALLATION

12.1 Appliance positioning

• The tumble dryer must be installed in

a clean position, where dirt does not

collect.

• Air must flow freely around the appli-

ance. Make sure that the front airflow

slots in the bottom of the appliance

are not blocked .

• To keep vibration and noise at the

minimum, when the tumble dryer op-

erates, it must be put on a stable and

flat surface.

• When the appliance is put in its per-

manent position, check if is fully level

with the aid of a spirit level. If it is not,

adjust the feet until it is.

• Do not remove the feet. Do not de-

crease the floor clearance through

thick carpets, bar of wood or equiva-

lent. This can increase the heat which

can cause interference with the opera-

tion of the appliance.

• The temperature of the hot air

which occurs in the tumble dry-

er can increase to 60 °C. The

appliance must not be instal-

led on the floor which is not re-

sistant to high temperatures.

• When the tumble dryer oper-

ates, the room temperature

must not be lower than +5 °C

and higher than +35 °C. This

can cause unwanted effect on

the performance of the appli-

ance.

• If it is necessary to move the

appliance, it must be moved

vertically.

• The appliance must not be in-

stalled behind a lockable door,

a sliding door, a door with a

hinge on the opposite side to

that of the appliance in such a

way that a full opening of the

tumble dryer is restricted.

It is possible to adjust the height of the

tumble dryer. To do that adjust the feet

(see picture).

15mm

12.2 Unpacking

CAUTION!

Before use all parts of the transport

packaging must be removed.

To remove the polystyrene blockages:

1.

Open the load door.

2.

Pull plastic hose with the polystyrene

blockages out from the drum.

12.3 Installation under a

counter

The appliance can be installed as free-

standing or below the kitchen counter

with correct space (see picture).

44

www.aeg.com

1 2 ... 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments