AEG HK604200IB User Manual download pdf (Page 12)

7. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

7.1 What to do if...

Problem Possible cause Remedy

You cannot activate or oper-

ate the hob.

The hob is not connected to

an electrical supply or it is

connected incorrectly.

Check if the hob is correctly

connected to the electrical

supply. Refer to the connec-

tion diagram.

The fuse is blown. Make sure that the fuse is

the cause of the malfunction.

If the fuse is blown again

and again, contact a quali-

fied electrician.

Activate the hob again and

set the heat setting in less

than 10 seconds.

You touched 2 or more sen-

sor fields at the same time.

Touch only one sensor field.

There is water or fat stains

on the control panel.

Clean the control panel.

An acoustic signal sounds

and the hob deactivates.

An acoustic signal sounds

when the hob is deactivated.

You put something on one

or more sensor fields.

Remove the object from the

sensor fields.

The hob deactivates. You put something on the

sensor field .

Remove the object from the

sensor field.

Residual heat indicator does

not come on.

The zone is not hot because

it operated only for a short

time.

If the zone operated suffi-

ciently long to be hot, speak

to an Authorised Service

Centre.

The heat setting changes

between two levels.

Power management function

operates.

Refer to "Daily use" chapter.

The sensor fields become

hot.

The cookware is too large or

you put it too near to the

controls.

Put large cookware on the

rear zones if possible.

comes on.

Automatic Switch Off oper-

ates.

Deactivate the hob and acti-

vate it again.

comes on.

The Child Safety Device or

the Lock function operates.

Refer to "Daily use" chapter.

www.aeg.com12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments