AEG HG755440SM User Manual download pdf (Page 10)

with disinfectants, stain or rust

removers and immersion cleaners.

6.2 Pan supports

The pan supports are not

resistant to washing in a

dishwasher. They must be

washed by hand.

1. Remove the pan supports to easily

clean the hob.

Be very careful when you

replace the pan supports

to prevent the hob top

from damage.

2. The enamel coating occasionally can

have rough edges, so be careful

when you wash the pan supports by

hand and dry them. If necessary,

remove stubborn stains with a paste

cleaner.

3. After you clean the pan supports,

make sure that they are in correct

positions.

4. For the burner to operate correctly,

make sure that the arms of the pan

supports are aligned with the centre

of the burner.

6.3 Cleaning the hob

• Remove immediately: melted plastic,

plastic foil, sugar and food with sugar.

If not, the dirt can cause damage to

the hob. Take care to avoid burns.

• Remove when the hob is sufficiently

cool: limescale rings, water rings, fat

stains, shiny metallic discoloration.

Clean the hob with a moist cloth and

non-abrasive detergent. After

cleaning, wipe the hob dry with a soft

cloth.

• To clean the enamelled parts, cap

and crown, wash them with warm

soapy water and dry them carefully

before you put them back on.

6.4 Cleaning the spark plug

This feature is obtained through a

ceramic ignition candle with a metal

electrode. Keep these components well

clean to prevent difficult lighting and

check that the burner crown holes are

not obstructed.

6.5 Periodic maintenance

Speak to your local Authorised Service

Centre periodically to check the

conditions of the gas supply pipe and

the pressure adjuster, if fitted.

7. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

7.1 What to do if...

Problem Possible cause Remedy

There is no spark when you

try to activate the spark gen-

erator.

The hob is not connected to

an electrical supply or it is

connected incorrectly.

Check if the hob is correctly

connected to the electrical

supply.

The fuse is blown. Make sure that the fuse is

the cause of the malfunction.

If the fuse is blown again

and again, contact a quali-

fied electrician.

www.aeg.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments