AEG HC452401EB User Manual download pdf (Page 16)

Problem Possible cause Remedy

comes on.

The electrical connection is

incorrect. The supply voltage

is out of range.

Speak to a qualified electri-

cian to check the installation.

comes on.

There is an error in the hob

because a cookware boiled

dry. Automatic Switch Off

and the overheating protec-

tion for the zones operate.

Deactivate the hob. Remove

the hot cookware. After ap-

proximately 30 seconds, acti-

vate the zone again. If the

cookware was the problem,

the error message goes out.

Residual heat indicator can

stay on. Let the cookware

become sufficiently cool.

Check if your cookware is

compatible with the hob.

Refer to “Hints and tips”

chapter.

comes on.

The cooling fan is blocked. Check if objects block the

cooling fan. If comes on

again, speak to an Author-

ised Service Centre.

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Give also

three digit letter code for the glass

ceramic (it is in the corner of the glass

surface) and an error message that

comes on. Make sure, you operated the

hob correctly. If not the servicing by a

service technician or dealer will not be

free of charge, also during the warranty

period. The instructions about the

Service Centre and conditions of

guarantee are in the guarantee booklet.

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in

units and work surfaces that align to the

standards.

8.3 Connection cable

• The hob is supplied with a connection

cable.

• To replace the damaged mains cable

use the following (or higher) mains

cable type: H05V2V2-F T min 90°C.

Speak to your local Service Centre.

8.4 Attaching the seal

1. Clean the worktop around the cut

out area.

www.aeg.com

16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comments to this Manuals

No comments