AEG F34300VI0 User Manual download pdf (Page 9)

than 21°dH, you can set the lowest water

softener level. It deactivates the salt refill

indicator.

If you use standard detergent or multi-

tablets without salt, set the proper

water hardness level to keep the salt

refill indicator active.

How to set the water softener

level

The appliance must be in programme

selection mode.

1. To enter the user mode, press and

hold the programme button until the

indicator

starts to flash and

the indicator comes

on with fixed light.

2. Wait until the indicator

goes off and the

indicator starts to flash. The

indicator

continues to flash.

The intermittent flashing of the

indicator refers to the current set

level.

• E.g. 5 flashes + pause + 5 flashes

= level5.

3. Press programme button repeatedly

to change the setting. Each time you

press programme button the level

number increases. After level 10 you

will start again from level 1.

4. Press the on/off button to confirm

the setting.

6.3 Acoustic signals

Acoustic signals sound when a

malfunction of the appliance occurs. It is

not possible to deactivate these acoustic

signals.

There is also an acoustic signal that

sounds when the programme is

completed. By default this acoustic

signal is deactivated but it is possible to

activate it.

How to activate the acoustic

signal for the end of

programme

The appliance must be in programme

selection mode.

1. To enter the user mode, press and

hold the programme button until the

indicator

starts to flash and

the indicator comes

on with fixed light.

2. Press immediately the programme

button.

• The indicator

comes on

with fixed light.

• The indicator

starts to flash.

3. Wait until the indicator

goes

off. The indicator

continues to flash.

• The end indicator indicates the

current setting: End indicator off

= Acoustic signal off.

4. Press the programme button to

change the setting.

• End indicator on = Acoustic signal

on.

5. Press the on/off button confirm the

setting.

7.

BEFORE FIRST USE

1. Make sure that the current level of

the water softener agrees with the

hardness of the water supply. If

not, adjust the level of the water

softener.

2. Fill the salt container.

3. Fill the rinse aid dispenser.

4. Open the water tap.

5. Start a programme to remove any

processing residuals that can still be

inside the appliance. Do not use

detergent and do not load the

baskets.

When you start a programme, the

appliance can take up to 5 minutes to

recharge the resin in the water softener.

It seems that the appliance is not

working. The washing phase starts only

after this procedure is completed. The

procedure will be repeated periodically.

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments