AEG X86264MG1 User Manual download pdf (Page 4)

www.aeg.com

4. CONTROLS



    

Button Function Led

L Turns the lights on/off at maximum strength. -

T1 Turns the motor on/off at speed one. Fixed.

T2 Turns the Motor on at speed two.

Press and hold the button for approximately 3 seconds,

with all the loads turned off (Motor and Lights), to turn the

Activated Charcoal Filter alarm on. The relevant LED ashes

twice to conrm.

To turn the alarm off, press the button again and hold for at

least 3 seconds. The relevant LED ashes once.

Fixed.

T3 Turns the Motor on at speed three.

Press and hold the button for approximately 3 seconds, with

all the loads turned off (Motor and Lights), to perform a reset.

The LED S1 ashes three times.

Fixed.

T4 Turns the Motor on at INTENSIVE Speed.

This speed is timed to run for 10 minutes. At the end of this

time, the system returns automatically to the speed that was

set before. If it is activated with the motor turned off, the hood

will switch to OFF at the end of the time.

Press and hold for 3 seconds to enable the remote control,

indicated by the LED ashing twice.

Press and hold for 3 seconds to disable the remote control,

indicated by the LED ashing just once.

Fixed.

S1 Signals the Metal Grease Filter saturation alarm, indicating that

it is necessary to wash the lters. The alarm is triggered after

the Hood has been in operation for 100 working hours. (Reset

see the parag. Maintenance).

Fixed.

When this is activated, it signals the Activated Charcoal Filter

saturation alarm, indicating that the lter must be changed;

the Metal Grease Filters must also be washed. The Activated

Charcoal Filter saturation alarm comes into operation after the

Hood has been working for 200 hours. (Activation and Reset

see the parag. Maintenance)

Flashing.

1 2 3 4 5 6 7 8 9 ... 71 72

No comments

AEG X86264MG1 User Manual Page 4