AEG L99695HWD User Manual Page 1

EN User ManualWasher DryerL 99695 HWD

DDigit areaTime of the dayWhen you activate the appliance the display shows the time of the day for someseconds. To adjust the clock, refer to "C

FTime saveThe indicator comes on when you set one of the programme dura-tion.Shortened timeExtra QuickG Indicator for air filtersHExtra rinsingThe val

5. PROGRAMMES5.1 Programme ChartProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)Washing/Drying

ProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)Super EcoCold3 kg1200 rpmMixed fabric (cotton

ProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)Refresh40°Cup to 1.5 kg Steam programme for co

ProgrammeSpinPre-washStains SoakExtraRinse 1)TimeSave2)DelayStartSpin/Drain 1) If the Permanent Extra Rinse option is activated, the

Dryness Level Type of fabric Load(kg)Spinspeed(rpm)Suggestedduration(mins)Iron DrySuitable for ironingCottons and Linen(sheets, tablecloths, shirts,et

Programmes Load(kg)Energyconsump-tion (kWh)Water con-sumption (li-tre)Approximate pro-gramme duration(minutes)Cotton Energy Saving Pro-gramme 60 °C1)9

to decrease the energy consumptionwhen:• You do not use the appliance for 5minutes before you pressStart/Pausebutton.All setting are cancelled.Press t

The programme durationincreases. This function isnot available with atemperature lower than40° C.8.12 SpinTouch button Spin to:• Decrease the maximum

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS.

10. DAILY USE - WASHING ONLY10.1 Before activating theappliance1. Open the water tap.2. Connect the mains plug to the mainssocket.10.2 Activating the

10.5 Liquid or powderdetergent1. 122. A3. B4.• Position A for powder detergent (factory setting).• Position B for liquid detergent.When you use the li

10.8 Starting a programmewith the delay start1. Touch button Delay Start again andagain to set the desired delayedstart.The display show the expected

When you activate theappliance again, the displayshow the end of the last setprogramme. Turn theprogramme knob to set anew cycle.2. Remove the laundry

At the beginning of thedrying cycle (3 – 5 min.)there could be a slightlyhigher sound level. This isthe compressor start and it isquite normal for com

12.1 NON-STOP programmeYou can wash and dry your laundrysetting a «non stop-programme».Proceed as follows:1. Press button On/Off for someseconds to ac

13. HINTS AND TIPSWARNING!Refer to Safety chapters.13.1 The laundry load• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey

Use the correct quantity of the watersoftener. Obey the instructions that youfind on the packaging of the product.13.6 Drying hintsPrepare the drying

14.2 DescalingIf the water hardness in your area is highor moderate, we recommend that youuse a water descaling product forwashing machines.Regularly

14.6 Cleaning the air filtersThe air filters collect the fluff. The fluff normally occurs when the clothesare dried in a washer-dryer.• At the end of

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible i

9.10. +Cleaning regularly the air filters with warm water allows you to have bestdrying performances. Clogged filter increases the drying time.WARNING

3. 4.125.126.7. 8.129.12 ENGLISH 31

14.8 Cleaning the inlet hose filter and the valve filterIt could be necessary to clean the filters when:• The appliance does not fill with water.• The

14.9 Emergency drainBecause of a malfunction, the appliancecannot drain the water.If this occurs, do steps (1) through (9) of'Cleaning the drain

Message Possible solution Make sure that the water tap is not clogged or is furredwith lime-scale. Make sure that the filter of the inlet hose and t

Problem Possible solutionThe appliance does not drainthe water.Make sure that you have not set a programme withoutdrain phase. Make sure that you hav

Problem Possible solution Use special products to remove the stubborn stains be-fore you wash the laundry. Make sure that you set the correct temper

CAUTION!Make sure that the drum isnot rotating. Wait till thedrum stops rotating, ifnecessary.Make sure that the waterlevel inside the drum is nottoo

• Remove the cardboard top.• Remove the polystyrene packagingmaterials.• Remove the internal film.• Open the door.• Remove the polystyrene piece fromt

• Pull up the appliance in verticalposition.• Remove the power supply cable andthe drain hose from the hose holders.• Remove the three bolts.• Use the

side, where the appliance door can not be fullyopened.• Connect the mains plug to the mains socket only atthe end of the installation. Make sure that

16.3 Installation on suspendedflooringSuspended wooden floors areparticularly susceptible to vibration.To help prevent vibration werecommend you place

16.6 The inlet hose20O20O45O45O• Connect the hose to the back appliance.Turn the inlet hose only left or right.• Loose the ring nut to set it in the c

• Making an U form with the drain hose.On the edge of a sink• Make sure that the plastic guide cannotmove when the appliance drains. Attachthe guide t

To a sink spigot• Refer to the illustration. Put the drain hosein the spigot and tighten it with a clip.• Make sure that the drain hose makes aloop to

Wool 1Spin Speed Maximum 1600 rpm1) Connect the water inlet hose to a water tap with a 3/4'' thread.2) The appliance works correctly if th

ENGLISH 45

www.aeg.com46

ENGLISH 47

www.aeg.com/shop132908860-A-082014

• Items such as foam rubber (latex foam), shower caps,waterproof textiles, rubber backed articles and clothesor pillows fitted with foam rubber pads s

level with the aid of a spirit level. If itis not, adjust the feet until it is.• To make sure the compressor worksproperly, wait 6 hours after theinst

3. PRODUCT DESCRIPTION3.1 Appliance overview1 2 3 41167895121314101Worktop2Detergent dispenser3Air filter(s)4Control panel5Door handle6Rating plate7Dr

3.3 Accessories1 2341 SpannerTo remove the transit bolts.2 Plastic capsTo close the holes on the rear side of thecabinet after the removal of the tran

4.2 DisplayA B C DEFGHIJKThe display shows:AThe text bar:• Guides you in the use of the appliance.• Shows the programme status and phase.• Shows alarm