AEG L99695HWD User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Items such as foam rubber (latex foam), shower caps,
waterproof textiles, rubber backed articles and clothes
or pillows fitted with foam rubber pads should not be
dried in the wash dryer.
Fabric softeners, or similar products, should be used
as specified by the fabric softener instructions.
Remove all objects from pockets such as lighters and
matches.
Never stop the wash dryer before the end of the
drying cycle unless all items are quickly removed and
spread out so that the heat is dissipated.
The final part of a wash dryer cycle occurs without
heat (cool down cycle) to ensure that the items are left
at a temperature that ensures that the items will not
be damaged.
Do not use water spray and steam to clean the
appliance.
Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
Before maintenance, deactivate the appliance and
disconnect the mains plug from the mains socket.
2.
SAFETY INSTRUCTIONS
2.1 Installation
Remove all the packaging and the
transit bolts.
Keep the transit bolts. When you
move the appliance again you must
block the drum.
Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
Do not install or use a damaged
appliance.
Obey the installation instruction
supplied with the appliance.
Do not install or use the appliance
where the temperature is less than
5°C or higher than 35 °C.
Make sure that the floor where you
install the appliance is flat, stable,
heat resistant and clean.
Do not install the appliance where the
appliance door can not be fully
opened.
Always move the appliance vertically.
The rear surface of the appliance
must be put against the wall.
Make sure that there is air circulation
between the appliance and the floor.
Adjust the feet to have the necessary
space between the appliance and the
carpet.
When the appliance is put in its
permanent position, check if it is fully
level with the aid of a spirit level. If it
is not, adjust the feet until it is.
To make sure the compressor works
properly, wait 6 hours after the
installation before using the
appliance.
ENGLISH
5
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 47 48

Comments to this Manuals

No comments