EN User ManualWashing MachineL61470WDBI
4.3 Phase indicatorsABCAfter you have pressed the button Start/Pause, the Washing indicator comes on.The appliance is operating.When you set a drying
ProgrammeTemperaturerangeMaximum loadMaximum spinspeedProgramme description(Type of load and soil level)Drying Synthetics 2 kg Drying programme for sy
ProgrammeSpinStains 1)TimeSave 2)ExtraRinseDelay StartEconomy 3) 1) The Stain option is not available with a temperature lower then 40°C.2) If
Programmes Load(kg)Energyconsump-tion (kWh)Water con-sumption (li-tre)Approximate pro-gramme duration(minutes)Cottons 60 °C 7 1.35 67 150EconomyCotton
7.5 Delay StartWith this option you can delay the startof a programme from 30 minutes to 20hours.The display shows the related indicatorand delay time
CAUTION!Make sure that no laundrystays between the seal andthe door. There is a risk ofwater leakage or damage tothe laundry.10.2 Filling the detergen
the appliance during the delay time,press the button Start/Pause to set theappliance to pause. When the indicatorDoor goes off , the door can be opene
time the drum continues to turn atregular intervals until water drain.Follow the below instructions to emptyout the water:• Turn the programme selecto
• The last minutes of the drying cyclethe appliance performs a cooling andanti-crease phase. The door is stilllocked. The display show a flashing .Wh
The released fluff could stick to thefabrics during the next cycle.This inconvenient increases withtechnical fabrics.To prevent the fluff in your laun
CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS.
• Always start a washing programmewith the maximum load of laundry.• If necessary, use a stain remover whenyou set a programme with a lowtemperature.•
14. CARE AND CLEANINGWARNING!Refer to Safety chapters.14.1 External cleaningClean the appliance only with soap andwarm water. Fully dry all the surfac
3. 4.MAX14.6 Cleaning the drain filterThe pump should be inspected regularly and particularly if:• The appliance does not empty and/or spin.• The appl
4. Release the emergency emptying hose,place it in the container and remove its capcover.125. When no more water comes out, unscrewthe filter cover by
14.7 Cleaning the inlet hose and the valve filter1.1232.3. 4.45°20°14.8 Frost precautionsIf the appliance is installed in an areawhere the temperature
First try to find a solution to the problem(refer to the table). If not, contact theAuthorised Service Centre.With some problems, the acousticsignals
Problem Possible solutionThe spin phase does notoperate or the washingcycle lasts longer thanusually.• Set the spin programme.• Make sure that the dra
Problem Possible solutionThe laundry is full of dif-ferent coloured fluff:The fabrics washed in the previous cycle released fluff of a dif-ferent colo
Remove the cardboard top. Remove thepolystyrene packaging materials.Remove the internal film.Open the door. Remove the polystyrenepiece from the door
12Remove the polystyrene protection from thebottom. Pull up the appliance in verticalposition.Remove the polystyrene block fitted on thedoor seal (if
1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible i
Put the plastic caps in the holes. You can findthese caps in the user manual bag.We recommend that you keep the packaging and the transit bolts for an
16.3 The inlet hose20O20O45O45O• Connect the hose to the back appliance.Turn the inlet hose only left or right.• Loose the ring nut to set it in the c
On the edge of a sink• Make sure that the plastic guide cannotmove when the appliance drains. Attachthe guide to the water tap or the wall.To a stand
To a wall-pipe• Directly to a built-in drain pipe in the roomwall and tighten it with a clip.You can extend the drain hose to maximum 400 cm. Contact
16-22 mm22±1,5 mm416mmX595-598 mmØ 35 mm14 mmDoorThe dimensions of the door should be:• width 595 - 598 mm• thickness 16-22 mm• the height X depends o
ABCEDWARNING!Do not remove the screw B.If the door has to be opened from left toright, invert the position of the plates E, themagnet D and the plate
www.aeg.com/shop132899510-A-172015
side, where the appliance door can not be fullyopened.• Connect the mains plug to the mains socket only atthe end of the installation. Make sure that
or pillows fitted with foam rubber pads should not bedried in the wash dryer.• Fabric softeners, or similar products, should be usedas specified by th
• The appliance must be earthed.• Always use a correctly installedshockproof socket.• Do not use multi-plug adapters andextension cables.• Do not pull
3. PRODUCT DESCRIPTION3.1 Appliance overview7 8 9101 234561Detergent dispenser2Control panel3Door handle4Rating plate5Drain pump filter6Feet for the a
To close the door, turn the deviceanticlockwise until the groove is vertical.4. CONTROL PANEL4.1 Control panel description4030 30ColdDelicate RinseSp
The display shows the following information:Duration of the set programmeWhen you set a programme, the display shows the duration in hours andminutes
Comments to this Manuals